Camco Q-Power 10 - Manual (Page 20)

4 OPER
ATION
USER MANUAL
Q - P O W E R S E R I E S P. 9
Q - P O W E R
S E R I E S
4.8 Mounting the Volume Control Security Cover
It is possible to install a solid protection over the volume controls to prevent
intentional or unintentional changes of the amplifier volume settings.
WARNING: Disconnect the amplifier from the mains before installing the
cover.
In the original state the holes needed to fix the security cover on both sides of
the volume knobs are hidden behind the plastic front label. In case you wish to
install the cover please first pierce two holes in the front label to facilitate the
screwing, as shown in the drawings.
To find the exact positions of the holes take the included cardboard template
you will find attached on the last page of this manual and place it on top of
the volume knobs. The positions of the hidden screw holes are indicated on
the template. Then firmly pierce and turn with a pointed tool (we recommend a
Philips PH recessed head screwdriver) through the cardboard and the label at
these positions to obtain a clean hole. You now should see the metal of the fine
pitch thread behind the label.
Then remove the cardboard template and fix the cover with the two included
M3 recessed threaded screws.
WARNING: Do not use any pointed tools (e.g. screwdriver) with a diameter of
less than 3,5 mm (0,38 in), as they might be stucked too deeply inside the screw
holes and damage internal components.