Exhaust filter changing, Exhaust filter, Power-mate® gäre – Kenmore 116.21513 User Manual
Page 14: Power-mate® care, Exhaust filter electrostatic, Warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EXHAUST FILTER CHANGING
warning
Fire and/or Electrical Shock Hazard
Do not operate with a clogged
exhaust filter or without the exhaust
filter or exhaust filter cover installed.
EXHAUST FILTER
ELECTROSTATIC
The electrostatic filter must be replaced
when dirty. Replace the filter when the
entire surface area is covered evenly. The
filter CANNOT be washed as it will lose
its dust trapping ability.
Replacement exhaust filters are availabie
through Sears Service Center under part
no, 817S258. See "Requesting Assistance
or Service"
1. PuH out and up
on the exhaust filter
cover to remove
from the motor
cover and lay aside
3, Piace the new
filter into the motor
cover with the
white side down.
Tsb
V Slot
2. When the
exhaust filter
becomes dirty,
remove it by
pulling straight up.
Exhaust
4, Reinstall the
exhaust filter
cover by insert
ing the tab into
the slot in the
motor coven
Press firmly to
snap exhaust fil
ter cover into
P
lAr*o
I-
POWER-MATE® GÄRE
Always follow all safety precautions when
cleaning and servicing the Power-Mate®
warning
Electrical Shock Or Persona!
Hazard
Injury
Disconnect electrical supply before
servicing or cleaning the unit
Failure to do so could result In elec
trical shock or personal injury from
cleaner suddenly starting.
14