G. how to change the number of icm – Brother FAX-175 User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4.
Press the START/COPY button to print out the current security code. You wiil see:
**** *********Q[jpp^|^'|‘ SEGURITY QQQE*********************
*
*
*
TAD SECURITY CODE: 000
*
*
*************************0j-^Q-j-j_l^p FAX“1 У5***************************
5.
To register a new TAD Security Code, say, 104, press FINE/PHOTO button once to
select the first digit "1".
6.
Press START/COPY button to register this digit.
7.
Press START/COPY button (don't touch the FINE/PHOTO button) to register "0".
24
8.
Press FINE/PHOTO button four (4) times to select the final digit "4".
9.
Press START/COPY button to register this final digit and the FAX-175 will
automatically print out:
**** DO YOU WISH TO MAKE THE FOLLOWING CHANGE? *******
* *
*
NEW TAD SECURITY CODE: 104
•k******ie*ie******-k*-k*ie**-k****
BROTHER FAX-175
The START/COPY lamp will start to blink when the printout is finished.
10. If your entries are incorrect, press the STOP button and then the START/COPY
button. The FINE lamp will start to blink. This will bring you back to step 3 where you
can select this procedure all over again.
If your entries are correct, press the START/COPY button to complete the selection
of numbers. Now you have two choices. Choice (1) allows you to continue with
registration of other parameters. To do so, you press START/COPY button again
which will bring you back to step 3 above and where you can use the FINE/PHOTO
button to select the desired parameter. Choice (2) is to terminate the registration
process by pressng the STOP button.
G.
How to change the number of ICM
The unit is capable of recording a total of 112 seconds worth of messages and memos. The
factory setting breaks up this total time into seven (7) messages of 16 seconds each. It is
possible, however, that you would prefer longer messages or shorter messages. Since the
total time must stay as 112 seconds, the longer the message the smaller the number of
messages. The table below summarizes your choices:
ICM TIME SELECTION
14 seconds
16 seconds
18 seconds
22 seconds
28 seconds
NUMBER OF MESSAGES
8
7 (this is the factory setting)
6
5
4