Brother P-TOUCH PC - Manual (Page 20)

ESC+i+M+byte
Sequence Function
Mode setting bit 0 ~ 4: Feed amount (default=large)
0 ~ 7 none
8 ~11 small
1 2 - 2 5 medium
26 ~ 31 large
bit 6: Auto cut (default=ON)
O O F F
1 ON
bit 7: Mirror print (default=OFF)
O O F F
1 ON
This command should be set before sending
data.
Mirror printing is not possible with non-laminated
(thermal film) tapes.
Feed amount is automatically set to large with
lettering tapes.
Description
ESC+i+P Print command for
continuous pages
Images longer than 27 cm can be printed contin­
uously on connected pages; invalid when the
print buffer is empty; prints even if the only data
in the print buffer are spaces.
ESC+\+S Status information
request I -8 header: 80h, 20h, 42h, 30h, 30h, 30h,
OOh,OOh
9 error code
bitO: no tape
biti: tape end
bit2: cutter jam
10 error code
bitO: tape change error
biti: print buffer full
bit2: transmission error
bit3 reception buffer full
II tape width (1 ~127mm)
0: no tape
12 tape type (0-127)
0: unidentified tape
1: laminated tape
2; lettering (iron copy)
3: Non-laminated (thermal film) tape
13-15 OOh (fixed)
16
mode (same as for “Mode setting”)
17 print density (same as for “Print density
and barcode controls”)
18-32 irrelevant
17