Craftsman 137.21602 - Manual (Page 18)

18 19 18 19
THE DUST BLOWER (FIG. D)
1. Locate the sawdust blower tubing (1).
2. Connect the PVC plastic end of the
tube to the bellows seat (2).
3. For best results, the dust blower
tube should be adjusted to direct air
at both the blade and the workpiece.
Fig. D
SAWDUST COLLECTION PORT (FIG.
E, F)
This scroll saw will accept a hose or
vacuum accessory (not provided)
to be connected to the sawdust
collection port (1) on the front of
base. If excessive sawdust buildup
occurs inside the base, use a wet/dry
vacuum cleaner or manually remove
sawdust by first unplugging the saw
from the power source, then removing
the three screws (2) on the left side
of saw holding the plate cover. After
cleaning all sawdust buildup, reattach
the plate and screws before restarting
the saw. This will keep your saw cutting
efficiently.
Fig. E
● To prevent fire hazard, clean and
remove sawdust from under the
saw frequently.
● To prevent sawdust build up inside
the saw housing, attach a vacuum
hose (3) to the sawdust collection
port (1) at the front of the scroll
saw. DO NOT operate the saw
with the hose in place unless the
vacuum is turned on.
NOTE: A 43-38 mm (1-11/16 in-1-1/2
in) dust port adapter (4) is provided for
your convenience.
Fig. F
1
2
2
1
1
4
3

WARNING !