Crestron electronic infiNET EX MLX-2 - Manual (Page 11)

Crestron MLX-2 infiNET EX™ LCD Handheld Remote
“PROGRAM DEVICE” Screen
PAGE 1/1
PROGRAM DEVICE
BASIC SETUP
VIEW TSID
SET RFID
RF CHANNEL
ACQUIRE
In Setup mode, use the menu buttons on either side of the function name displayed
on the “PROGRAM DEVICE” screen to select that function.
The following paragraphs describe the setup options in the order listed in the menus.
NOTE: If this is a first-time setup or you are acquiring the MLX-2 to a new
gateway, the acquire function must be performed before attempting to do the other
setup operations. If the unit is already acquired and you are simply modifying one of
the setup options, it is not necessary to do the acquire function, proceed directly to
“BASIC SETUP Functions” that begin on the next page.
To begin Setup mode, press one of the menu buttons on either side of the ACQUIRE
option. The screen displays navigation instructions that apply throughout the setup
process.
Basic Navigation Screen
PAGE 1/1
Use < / > to
navigate. At any
time, press and
hold HOME to
exit. Press >
to continue.
ACQUIRE Function
NOTE: Before beginning the acquire function, make certain that the target
CEN-RFGW-EX gateway is in Acquire mode.
This function lets you add the MLX-2 to your infiNET EX network. From the basic
navigation screen, shown to the left, press
h next to the HOME button to enter the
acquire function. Press h again to start the process to add the MLX-2 to the network.
NOTE: Pressing the HOME button once typically takes you from the current setup
function you are performing back to the “BASIC SETUP” screen. Multiple presses
or holding the button will exit Setup mode.
The process to
add this node
to your network
may take up to
90 seconds.
Press > to
Continue.
PAGE 1/1
Please wait for
the add process
to complete.
ADD ACTIVE
PAGE 1/1 PAGE 1/1
Success!
You have added
this remote as
a new node to
Your RF network.
Press > to
continue
If the MLX-2 is added to the network, the screen displays a “Success!”
message. Press h to continue. The display returns to the “PROGRAM
DEVICE” screen. Press HOME twice to exit the Setup mode so Toolbox
can recognize the device being acquired to the gateway.
If the MLX-2 is already acquired to another network, when you press h to
add it to this new network, a screen message instructs you to perform a
factory reset in order to acquire it to the new network. Refer to “Factory
Reset Procedure” on page 11.
If the acquire process is not successful, the screen displays the following
message for approximately five seconds: “The node addition failed. Try
again or reference the manual for more assistance. Press h to continue.”
Refer to “Troubleshooting” on page 18.
Operations Guide – DOC. 6839A infiNET EX™ LCD Handheld Remote: MLX-2 • 7