Cary Audio Design DVD 8 - Manual (Page 21)

CHANGING THE DEFAULT SETTINGS
20
output will be stereo. For multi-channel content only the left front and right front channels
will be re-produced.
• Stereo (default) - This mode down-mixes decoded multi-channel (5.1ch) audio to 2-
channel stereo output. For stereo content the output will be stereo. For multi-channel
content the surround and center channels will be mixed with the left and right front
channels. Recommended for use with TV sets or stereo receiver/amplifiers.
• V. Surround - Virtual Surround. This mode creates a virtual surround effect from stereo or
multi-channel audio contents.
• 5.1 CH – This mode enables 5.1ch decoded analog audio output. The number of actual
output channels depends on the disc.
...........................................................................................................................................................................
FRONT SPEAKER
Use this to set the sound filtering control for the front speakers. The options are:
• Large (default) – Choose if the front speakers are large. Bass frequencies are passed to
the front speakers.
• Small – Choose if the front speakers are small. Bass frequencies are not passed to the
front speakers to reduce possible distortion.
...........................................................................................................................................................................
CENTER SPEAKER
Use this to set the sound filtering control for the center speaker. The options are:
• Large – Choose if the center speaker is large. Full frequency range sound is passed to the
center speaker.
• Small (default) – Choose if the center speaker is small. Bass frequencies below the
crossover frequency are not passed to the center speaker to reduce possible distortion.
• Off – Choose if there is no center speaker.
...........................................................................................................................................................................
REAR SPEAKER
Use this to set the sound filtering control for the rear speakers. The options are:
• Large – Choose if the rear surround speakers are large. Full frequency range sound is
passed to the rear speakers.
• Small (default) – Choose if the rear surround speakers are small. Bass frequencies are
not passed to the rear speakers to reduce possible distortion.
• Off – Choose if there are no rear speakers.
...........................................................................................................................................................................
SUBWOOFER
Use this to enable/disable the subwoofer output. The options are:
• On – Subwoofer output is enabled.
• Off (default) – Subwoofer output is disabled.
...........................................................................................................................................................................
CHANNEL DELAY
Use this to set the delay time for the center, rear speakers and the subwoofer. The delay is to
compensate for the audio propagation time difference caused by the distance difference of the
speakers to the listener.
• Press the UP/DOWN ARROW buttons to select the speaker to set the distance difference.