Bosch WFK 2401 - Manual (Page 13)

drum with POWER WASH selected. The washer then
heats the water to the selected wash temperature. By
raising the temperature from cold through to the set
temperature all components of the detergent are
activated in stages for best stain removal and
cleaning results.
TYPICAL CYCLES
If there is still some question as to how the Bosch
washer is set for various washing duties refer to
Table 1, CYCLE SELECTION CHART and go through
the step by step suggestions and re-read the
OPERATION section. This will usually clear-up any
remaining questions.
Note: Water Level: Another aspect of the
Sensotronic Pius system is the load sensor
that will automatically adjust the water level in
the Boscti washer to accommodate the type
and sizé Of load.
VI. Press the “START’ button. The “START"
indicator light will stop flashing and become
illuminated, the washer will start, the “Door
Locked” light will become illuminated and
the washer will continue to the end of the
selected cycle. The cycle indicator lights will
display the cycle that is running and the
"Cycle Countdown” alphanumeric display
will indicate the estimated time remaining
until the cycle ends. See Figure 14.
Wish Rinse/Spfn DoorLocfcid CrcKCUMnHi
On/Oli
#
start Pr»- Quick Rinse Power Deiar Start
wash Wash Plus Wash Hours
# • • » • •
Figure 14.
Notes: 1. The Bosch washer’s Sensotronic Plus, a
sophisticated sensor technology package,
will constantly monitor, control and optimize
VII.
^ ■ -..........................................................................^
displayed in the alphanumeric display may
therefore change to accommodate the
change in a sensed condition; such as
unbalanced load, excessive suds,
extremely large or small loads, etc,
2. The Bosch washer will often start and stop
while operating as it changes drum rotation
direction and makes various checks and
adjustments to accommodate the load. This
stopping and starting is normal.
At the end of the cycle the washer will stop
the letters “CL” will be displayed in the ’
alphanumeric display and there will be an
"End of Cycle" signal.
“End of Cycle” Signal
The washer leaves the factory with the “End Of
Cycle" signal turned on and set to the loudest
position. To reset the “End of Cycle" signal to a lower
level, or turn it off completely;
Before the beginning or after the end of a cycle
depress and hold in the “PREWASH" button. After
approximately 3 seconds the signal will begin to
sound. The volume level of the sound may be
changed by holding the button in until desired volume
level or “OFF" setting is reached. The setting will be
stored for future use until altered.
VIII. If you have the speed selector set to “NO
FINAL SPIN” the letters "CL" will be
displayed, but the “Door Locked" light wilt
be on and the door will be locked. To bring
the cycle to the point where the door can be
opened you must perform one of the
following steps:
1. The wash must first be spun out, by
setting the speed selector to the desired
spin speed or "INTERVAL SPIN”,
or,
2. The water in the wash must be drained by
setting the cycle selector to DRAIN (6).
13