Cobra Electronics PR4750wx - Manual (Page 9)

Intro Operation Customer
Assistance Warranty
Notice
Main Icons
Secondary Icons
Customer Assistance Warranty Introduction
13 Nothing comes close to a Cobra ®
Operation
Intro Operation Customer
Assistance Warranty
Notice
Main Icons
Secondary Icons
12 English
Mode Functions
Operation
Intro Operation Customer
Assistance Warranty
Notice
Main Icons
Secondary Icons
Intro Operation Customer
Assistance Warranty
Notice
Main Icons
Secondary Icons
10 Memory Locations
•
Your microTALK ® radio has 10 Memory Locations for storing
your most frequently used channels and channel/privacy code
combinations. These Memory Locations can be selected individually
or can be scanned. (See page 20 for memory location scan.)
To program a memory location:
1. Press the Lock/Mode button until the
Memory icon and the memory location
flash on the display.
2. Press the Channel Up or Channel Down
button to select the memory location
(0 through 9).
If a location has been programmed
before, its associated channel/privacy
code will be shown on the display.
3. Press the Hi•Low/Enter button to enter
a new memory location or edit an already
programmed memory location. The channel
numbers will flash on the display.
4. Press the Channel Up or Channel Down
button to select a channel (1 through 22).
5. Press the Hi•Low/Enter button.
The CTCSS icon and privacy code
numbers will flash on the display.
Hi•Low/Enter Button
Memory Icon
Lock/Mode Button
Channel Buttons
6. Choose one of the following:
a. Press the Channel Up or Channel Down
button to select a CTCSS privacy code
(01 through 38) for the channel.
b. Press the Hi•Low/Enter button to
switch from CTCSS to DCS. The DCS
icon and privacy code numbers will
flash on the display. The Channel Up
or Channel Down button can then be
used to select a DCS privacy code
(01 through 83) for the channel.
If “OF” flashes in place of the privacy
code numbers, a privacy code is
already set in the opposite (CTCSS
or DCS) system. Press the Channel Up
or Channel Down button to cancel
the opposite code and select a privacy
code from the active system for the
selected channel.
7. Choose one of the following:
a. Press the Hi•Low/Enter button to enter
the channel/privacy code in the selected
memory location and return to Step 1
to program another memory location.
b. Press the Lock/Mode button to
enter the channel/privacy code in
the selected memory location and
proceed to other functions on the
channel/privacy code displayed
before you entered mode functions.
c. Press the Talk button to enter the
channel/privacy code in the selected
memory location and exit mode functions.
Upon release of the Talk button, the
radio will enter Standby mode on the
channel/privacy code just entered.