Campbell Hausfeld WL6700 Series - Manual (Page 4)

Important Safety Information
InStruCtIonS PertAInIng to A rISk oF FIre, eLeCtrIC ShoCk, or Injury
to PerSonS
This manual contains important safety, operational and maintenance information. If
you have any questions, please call 1-800-543-6400 for customer assistance.
Since the air compressor and other components (material pump, spray guns, filters,
lubricators, hoses, etc.) used, make up a high pressure pumping system, the following
safety precautions must be observed at all times:
CALIFornIA ProPoSItIon 65
This product or its power cord may contain chemicals, including lead,
known to the State of California to cause cancer and birth defects or
other reproductive harm. Wash hands after handling.
You can create dust when you cut, sand, drill or grind
materials such as wood, paint, metal, concrete, cement, or
other masonry. This dust often contains chemicals known to cause cancer, birth
defects, or other reproductive harm. Wear protective gear.
Breathable Air Warning
This compressor/pump is not equipped and should not be used “as is” to supply
breathing quality air. For any application of air for human consumption, the air
compressor/pump will need to be fitted with suitable in-line safety and alarm
equipment. This additional equipment is necessary to properly filter and purify
the air to meet minimal specifications for Grade D breathing as described in
Compressed Gas Association Commodity Specification G 7.1 - 1966, OSHA 29 CFR
1910. 134, and/or Canadian Standards Associations (CSA).
DISCLAIMer oF WArrAntIeS
In the event the compressor is used for the purpose of breathing air application
and proper in-line safety and alarm equipment is not simultaneously used,
existing warranties shall be voided, and Campbell Hausfeld disclaims any liability
whatsoever for any loss, personal injury or damage.
generAL
a. To reduce the risks of electric shock, fire, and injury to persons, read
all the instructions before using the tool. Failure to follow warnings,
dangers, and cautions could result in DEATH or SERIOUS INJURY.
b. Be thoroughly familiar with the controls and the proper use of the
equipment. Follow all instructions. Contact your Campbell Hausfeld representative
if you have any questions.
c. Follow all local electrical and safety codes as well as in the US, National Electrical
Codes (NEC) and Occupational Safety and Health Act (OSHA).
d. Only persons well acquainted with these rules of safe operation should be
allowed to use the unit.
Safety Guidelines
This manual contains information
that is very important to know and
understand. This information is
provided for SAFETY and to PREVENT
EQUIPMENT PROBLEMS. To help
recognize this information, observe the
following symbols.
Danger indicates
an imminently
hazardous situation which, if not avoided,
WILL result in death or serious injury.
Warning indicates
a potentially
hazardous situation which, if not avoided,
COULD result in death or serious injury.
Caution indicates
a potentially
hazardous situation which, if not avoided,
MAY result in minor or moderate injury.
Notice indicates
important
information, that if not followed, may
cause damage to equipment.
IMPORTANT: Information that
requires special attention.
Safety Symbols
The following Safety Symbols appear
throughout this manual to alert you
to important safety hazards and
precautions.
Operating Instructions and Parts Manual
www.chpower.com
Wear Eye and
Mask Protection
Read Manual
First
Risk of Fire
Wear Eye and
Ear Protection
Risk of
Electrocution
Hot Parts
Risk of
Explosion
Risk of Falling
Risk of Fumes
4