Campbell Hausfeld WL6700 Series - Manual (Page 10)

10
Operating Instructions and Parts Manual
www.chpower.com
Assembly
tooLS requIreD For ASSeMbLy
u Ratchet with 3/8 inch Socket
u (2) Wrenches
hAnDLe ASSeMbLy
1. Slide handle into shroud holes,
making sure handle is on the outside
of the bracket and the holes of the
handle line up with the holes of the
tank bracket.
2. Insert screws through handle and then
the bracket. Using a ratchet with 3/8
inch socket, tighten screws to hold the
handle in place.
InFLAtIon hoSe ASSeMbLy
1. Apply thread tape to both ends of the
recoil hose to prevent leaks.
2. Thread the coil hose into the fitting on
the shroud. Use 2 adjustable wrenches
to tighten the connection by holding
the bottom wrench steady and
tightening with the top wrench (See
Figure 10).
3. Screw blow gun onto the end of the
coil hose. Use 2 adjustable wrenches
to tighten the connection by holding
the bottom wrench steady and
tightening with the top wrench.
Once the recoil hose and blow gun are
attached, make sure no pressure is in
tank before replacing. Recoil hose and
blow gun must be installed for unit to
operate properly.
Figure 9 - handle assembly
Figure 10 - Inflation hose assembly
Apply thread tape to both
ends of the recoil hose to
prevent leaks