Crest Audio Stereo Amplifier - Manual (Page 27)

Crest Audio Pro Series Power Amplifiers Appendix B
20Hz-20kHz, <0.1% THD+N Typical Music Prog. Material
3500W 5000W
5000W 7500W
7000W 10,000W
10,000W 15,000W
105V
150V
20 Hz-20 kHz, -3dB @ 53kHz
20 Hz-20 kHz, +0/-0.2 dB
Clip Limit, IGM, AutoRamp, High Temp, short-circuit,
DC voltage, turn-on/off transient, sub/ultrasonic input.
<0.02%
0.05%
580:1
>60 dB
2.24V RMS
X40
>20k
Ω
> -100 dB
> -60dB
H
Female XLR Input (pin 3+), Octal Socket
Single screw solderless copper output lugs.
29,200 µF
100V–240V, 50–60Hz
2.0A per line cord
13.0A per line cord
25.0A per line cord
35.6A per line cord
4450 BTU/hr
7908 BTU/hr
Rear to front tunnel, variable speed DC fan, 235 CFM max.
Front panel: 2 attenuators, circuit breaker/power switch; Rear
panel: mode switch, signal ground lift jumper.
Clip/Limit, Signal, Temp/DC, Active
12 ga. steel chassis, 0.075" (1.9mm) aluminum front panel
7" x 19" x 20.5" (19.5" to end of rear ears),
178mm x 483mm x 521mm (496mm to back of rear ears)
145 lbs (65.83 kg.), 137 lbs (62.20 kg.)
5 years, parts and labor†
2
Ω
Stereo Power
1
Ω
Stereo Power
4
Ω
Bridged Mono Power
2
Ω
Bridged Mono Power
Max RMS Output Voltage (each channel)
Peak Output Voltage (each channel)
Frequency Response (+0 / -0.3dB, 1W/8
Ω
)
Power Bandwidth (rated power at 4
Ω
, 1% THD+N)
Protection Circuitry
THD+N (rated power at 4
Ω
, 1kHz)
SMPTE IMD (rated power at 8
Ω
, 60Hz & 7kHz)
Damping Factor (10-400Hz at 8
Ω
)
Input CMRR (1kHz)
Input Sensitivity (rated power at 4
Ω
)
Voltage Gain
Input Impedance (balanced)
Hum and Noise (“A” weighted, full power, 4
Ω
)
Crosstalk (“A” weighted, full power, 4
Ω
)
Class
Input Connectors (per channel)
Output Connectors (per channel)
Filter Storage
Power Supply (factory configured)
Idle Current Draw (120V)
1/8 Power Curr. Draw (typical music, 120V/4
Ω
)
1/3 Power Curr. Draw (continuous music, 120V/4
Ω
)
Max Curr. Draw (circuit breaker rating, 120V/4
Ω
)
Thermal Emissions (1/8 Power, 4
Ω
)
Thermal Emissions (1/3 Power, 4
Ω
)
Cooling
Controls
LED Indicators (per channel)
Construction
Dimensions (Height x Width x Depth)
Gross Weight, Net Weight
Warranty
† USA, Canada, U.K., and many other countries. Power figures are watts per channel, both channels driven. Crest Audio reserves the right
to make improvements in manufacturing or design which may affect specifications. Crest Audio specification literature is available in
downloadable PDF file format; visit our website at http://www.crestaudio.com. ©1997 Crest Audio Inc. 12/15/97
Appendix B - General Amplifier Specifications (Model 10001)