Channel Vision IC503 - Manual (Page 2)

2
Model IC503
Installation:
h
h
h
h
h
Use the provided template to mark and cut a 6½” hole in
drywall away from ceiling joists.
We recommend wiring with AWG 16 or larger, stranded
wire.
For proper phasing, both voice coils must be wired alike.
Connect red wires to red terminals on speaker and to red
or plus terminals on amplifier.
Install IC503 in the hole. Tighten the mounting screws.
The mounting dog ears will rotate outward and grip the
drywall.
To control the volume of the speaker locally, use an
impedance matching volume control, such as the
Channel Vision VC-302.
Mounting screws (4)
3
Specifications:
Frequency range:
Power Handling:
Drivers:
Impedance:
Finish:
Dimensions:
55Hz - 20kHz ± 3dB
50 Watts
1- .5” Mylar tweeter
1- 5.25” polypropylene woofer
8 ohms
ABS plastic
8” OD. 3
(Depth from surface of wall board) ” Deep
Specifications subject to change without notice.
Features:
Cost Effective
Easy to install
5.25” High performance in-ceiling loudspeaker
Mica-filled polypropylene woofer with butyl rubber surround
Small perforated designer grille
Recommended power: 50W (peak)
Pre-construction brackets sold separately (model IC52B)