1product safety – Carl Zeiss Camera Lens User Manual
Page 3
Sharp Max
Carl Zeiss
Camera Lens Division
Bedienungsanleitung Sharp Max 12_02E.doc Status 12 / 2002
Page 3 of 11
1
Product safety
The unit described in this manual has been designed and tested in accordance with Carl
Zeiss safety standards and with national and international regulations. A very high
degree of instrument safety is thus ensured.
We would like to inform you on the safety aspects involved in operating the instrument.
This chapter contains a summary of the most important precautions to be observed.
Further safety notes are also contained in other parts of this manual; they are marked
with frames. Please pay special attention to these safety notes.
Safety is only ensured when this instrument is operated properly. Please read through
this manual carefully before starting up this unit. You may obtain further information from
our service organization.
1.1 CE marking
The version supplied of this unit meets the requirements stipulated in the 89/336/EEC
"Electromagnetic Compatibility" and 73/23/EEC "Low Voltage" Directives.
1.2 Intended use
The unit must only be used for the measurements described in this manual. The
manufacturer will not assume any liability for different measuring procedures.
1.3 Standards
The unit described in this manual is short-circuit-proof and has been designed in
compliance with the following standards:
-
IEC / EN 61010 - 1
IEC / EN 60825 - 1
The unit contains light-emitting diodes (LEDs). This is a laser class 1 instrument as
defined by IEC/EN 60825-1:(2001).
The production, inspection, maintenance and repair are performed in compliance with
German and international regulations (Good Manufacturing Practice).
The unit is a protection class 3 instrument.