Kenwood KES-3 - Manual

EXTERNAL SPEAKER KENWOOD
r\co o
KENWOOD CORPORATION
INSTRUCTION MANUAL
©PRINTED IN JAPAN B50-8327-08(M)(T)
90/12 1110 9 8 7 6 5 4 3 2 1 89/12 1110 9 8 7 6
Thank you for purchasing the new External Speaker.
■ BEFORE OPERATION
IMPORTANT:----------------------------------------------
1. Please read this instruction manual carefully before
placing your Speaker in service.
2. SAVE THIS INSTRUCTION MANUAL.
ISPECIFICATIONS
Speaker size
Maximum input power
Impedance
Frequency responce
Plug
Dimension ( W x H x D )
WëîghT
Note: —
50x 90 mm
5 W
4 Q
300 to 9,000 Hz
</)3.5 mm
1 1 4 x 6 6 x 5 5 mm
4-1/2" X 2-19/32"
X 2-5/32"
‘35tTgl077TTüT '
Ratings are subject to change without notice due
to advancement in technology.
lACCESSORIES
Please unpack your new Speaker carefully, and
confirm that the accessories listed below are includ­
ed in the box.
Self-tapping screw............ N44-4012-45....2 ea.
Flat washer........................N15-1040-45....2 ea.
Instruction Manual............B50-8327-XX . . . 1 sheet
IMAINTENANCE
Cleaning
1. Do not use any type of abrasive pad, thinner,
benzine or any substances which may damage
the unit.
2. Wipe the front pannel and other exterior surfaces
of the unit with a soft dry cloth or a soft cloth
lightly moistened with water.
■INSTALLATION INSTRUCTIONS
1. Select the desired mounting position.
2. Loosen the two mounting screws and remove
the bracket from the speaker (Fig. 1).
3. Use the bracket as a template to locate the holes
and mark the position of the two mounting
screws.
4. Drill the two holes that were just marked. Use
a 1 / 8 " drill for self-tapping screws.
5. Secure the bracket with two self-tapping screws
(Fig. 2).
6. Attach the speaker to the bracket, temporarily.
7. The angle of the bracket may be adjusted to any
of several possible angles. Select the desired
angle.
8. Hold the speaker in position and tighten thei
bracket screws.
Fig. 1
06-30-505-00