Operating instructions, To compensate the sound for general home use, Select a desired equalizer pattern – Kenwood KC-993 User Manual
Page 12: 2 start recording, Select car st or headphone st according
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Operating instructions
When the cassette deck is connected to the TAPE 2/
ADAPTOR jacks, be sure to set the TAPE 2 /ADAPTOR
selector to the TAPE 2 position.
■ INPUT SELECTOR knob
Set this selector only when the power is turned off.
■Ordinary tape recording
■Tape dubbing (TAPE 1 -► TAPE 2)
Note;
The input source cannot be changed over while the cassette deck
connected to this unit via the system cootrol cord is in the record
mode. When it is required to change the input source, put the cassette.
deck in the stop mode beforehand.
(Recording sound with equalizer effect applied (TAPE 1 only)
To compensate the sound for general home use
^ Select a desired equalizer pattern.
Select a desired equalizer pattern from among the MANUAL
and REFERENCE preset equalizer patterns. See page 14, 15.
You can also create an equalizer pattern of your own. See
page 16.
2 Start recording.
To compensate the sound for use in a car or with
stereo headphones.
Select CAR ST or HEADPHONE ST according
to your purpose,
gg^i.,
button is pressed the
setting changes in the following order:
l~ CAR ST ^ HEADPHONE ST -
2 start recording.
12
KC-993 (En)