Casablanca Fan Company Atria C18GXXXF - Manual (Page 16)

Atria
™
16
5
Fasten one of the two wall plates (white or ivory)
to the wall control using the two wall plate screws.
6
Set the fan pull-chain speed to HIGH and
the wall control fan speed knob to HI. Return
power to the panel and test the controller.
CAUTION:
Ñ
Failure to set the fan pull-
chain speed to HIGH can result in faulty
operation of the fan and damage to the
wall control.
Operating the W-81 Wall Control
Turn the upper knob to the desired fan speed. •
Turn the lower knob to the desired light setting. •
Attaching the Canopy Hatch
7
Tuck the wires into the canopy with the wire
nuts pointed toward the ceiling. Place the BLACK and
WHITE wires on opposite sides of the canopy. All wires
should be clear of the canopy opening. Tilt the motor
housing and downrod to install the canopy hatch.
8
Use the last remaining canopy screw and
lock washer to secure the canopy hatch. Straighten
the fan and ensure all parts are tightly secured.
Check for movement at the following joints:
Between the canopy and the ceiling •
Between the canopy and the •
downrod and ball assembly
STEPS 7-8
Canopy screw
and washer
Canopy
Canopy hatch
NO DRILL
STEP 5
Wall plate
screws (2)