Howto ooerate video components – Kenwood KR-V990D User Manual
Page 34
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
KR-V990D tEn)
Refer to the following table for the type of remote control operations available for each video component. Each key on the table
operates the selected component as shown in the respective column. {The set up code for each component must be entered
beforehand. -»QS)
^
.
, r—
"Connecting the repeater"
"System set up"
Howto ooerate video components
...' —;i: .1: ~
..... ......
I
Turn on the receiver.
I
Set the input selector to the component you
want to control.
I
Use a component control selection key to
select the component you want to control.
I
Refer to the "Remote control key operation
table" and press the key corresponding to the
• Be sure to point the remote control at the IR receptor on the receiver
when operating the remote control, even when operating other com
ponents.
Although each setup code is designed to work with a number of different models, certain codes may not work with some models. (Also, certain
codes may only operate some of the functions available on a given model.)