9-4 recording – Kenwood TM-441A User Manual
Page 36
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5-9-4 Recording
# Recording an incoming receive signal manually.
1. Select the desired operating frequency. Recordings
can be made from the VFO mode, the Memory Mode
or the Call Channel mode.
2. Press the F key for longer than a second, then press
the DR/DT key while the F indicator is flashing to en
ter the DRS setting mode.
The DRS indicator should turn on in the display.
Select the desired phrase number by rotating the
tuning control.
3. Press the V F O / M ^ V key to begin recording. The
recording time indicator will show the elapsed time
of the recording.
---- Elapsed time
4. Recording will stop when the time indicator reaches
“00”.
To
continue
recording
from
the
same
frequency rotate the tuning control to the next
phrase number and then press the V F O / M ^ V key
again to begin recording. Recording will stop when
any front panel key is pressed.
# Recording Signals from the Microphone
1. Press the F key for longer than 1 second, then press
the D R / D T key while the F indicator is flashing to
enter the DRS setting mode. The DRS indicator
should turn on in the display. Select the desired
phrase number by rotating the tuning control.
2. Press the M R / M key to start recording from the
microphone. The recording time indicator will
indicate the elapsed time of the recording. If you
wish to transmit the same message while recording
you should press the microphone PTT switch before
you press the MR/M key.
/ U.S.A. \
\ version /
So66
3. The recording will stop when the elapsed time
indicator reaches “00”. If you wish to continue
recording you will need to rotate the tuning control
to the next phrase number and press the MR/M key
again.
Recording will stop when any front panel key is
pressed.
36