Removing open scan channels, Salect, U i i – Uniden UH077 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMOVING OPEN SCAN CHANNELS
When the radio is initially powered up from the box, all 40 channels will be programmed into
the OPEN SCAN MEMORY.
If you do not wish toscananyparticularchannels(e.g.ifoneormorechannelsare continu
ally busy and always causing the scanning function to pause), you may remove these
channels from the scan group using the following sequence.
1. Select fhe NORMAL mode by selecting the SCAN switch (3) to the OUT position.
2. Select the OPEN SCAN mode by selecting the OS/GS Select switch (4) to the IN posi
tion. The OS indicator (11) should be lit. The GS indicator should NOT be lit.
3. Rotate the CHANNEL SELECTOR switch (20) until the channel you wish to REMOVE
is displayed on the LED CHANNEL indicator (12).
Note that MEM indicator is lit, showing you that this channel is currently included in the
scan group.
4. PRESS and HOLD the MEM switch (16) for about 2 seconds until a BEEP is heard
twice.
NOTE: that the MEM indicator is now extinguished.'
Select
NORMAL
Satect
OPEN SCAN
Salect
CHANNEL
Ratnm
CHANNEL
MEM' Liflht
OFF
Big
[53
U I I
I u
The selected channel has now been removed from the scan group and will not be included
when scanning has commenced and the MEM indicator will not light on that channel.
Continue steps 3 and 4 to remove any other channels you do not wish to scan.
— 1 1 -