Kenwood CAW1301-05 - Manual (Page 2)

PASH DISASSEMBLY INSTRUCTIONS
1) Carefully unsnap and pull forward the vent/clock assembly from above
the factory radio.
2) Unplug the wire harnesses from the rear of the vent/clock assembly and
remove assembly.
3) Remove the (2) 10mm bolts securing the upper radio/climate control
brackets to the sub-dash.
4) Carefully remove the ashtray assembly from below the climate controls.
5) Remove the (2) 10mm bolts securing the lower radio/climate control
brackets to the sub-dash.
6) Carefully pull radio/climate control assembly forward, disconnect all wire
harnesses and antenna lead wire from radio and climate controls and
remove entire assembly.
7) Remove the factory climate control unit from fhe factory brackets.
KIT ASSEMBLY INSTRUCTIONS
Single DIN Mount Applications
1) Attach the left and right side brackets to the main bracket.
2) Insert pocket into lower section of ttie main bracket.
3) Attach left and right side brackets to the rear of the pocke* using
screws supplied.
4) Insert DIN sleeve from your new radio into the upper section of fhe
installation kit.
5) Depress the tabs from inside the sleeves opening upward, outward, and
downward to secure sleeve to the installation kit.
6) Install radio into sleeve and lock into place.
7) Attach a rear support bracket to the rear of the new radio and adjust as
necessary to attach to the rear support stud located on the back of the
pocket using the small phillips screw supplied with kit.
KIT ASSEMBLY INSTRUCTIONS
Single ISO Mount Applications
1) Attach the left and right side brackets to the main bracket.
2) Insert pocket into lower section of the main bracket.
3) Attach left and right side brackets to the rear of the pocket using
screws supplied.
4) Attach climate controls to the top of the kit using factory screws.
5) Attach (1) ISO Spacer to the inside of upper section on both Left & Right mounting
brackets as shown in Fig. A.
6) Insert ISO mountable radio between ISO mount brackets and loosely
attach to sides of radio using screws provided with radio when possible or
hardware included with kit.
7) Slide radio components forward or backward for desired look and tighten screws.
8) Attach a rear support bracket to the rear of fhe new radio and adjust as
necessary to attach to fhe rear support stud located on the back of the
pocket using the small phillips screw supplied with kit.