Radio back panel connectors – Uniden GRANT User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
13.
CHANNEL INDICATOR: Light Emitting Diode(LED) indicates the channel
number in use.
14.
CHANNEL SELECTOR KNOB; This knob selects the desired channel for
transmission and reception. Al( channels, except channel 9, may be used for
communications between stations. Channel 9 has been reserwed by the F.C.C. for
emergency communications involving the immediate safety of individuals or
immediate protection of property. Channel 9 also may be used to render
assistance to a motorist. This is an F.C.C. rule and applies to all operators of
citizens band radios.
15. CH9 INDICATOR : Lights to show that the CH9 Switch has been activated.
16. TX/RX INDICATOR: This indicator lights red when the transmitter is in opera
tion and lights green when the receiver is in operation.
RADIO BACK PANEL CONNECTORS
17,
ANTENNA CONNECTOR: This female connector permits connection of the
transmission line cable male connector (PL-259) to the transceiver.
18. PUBLIC ADDRESS SPEAKER JACK; An external 8 ohm 4-watt speaker must
be connected to the PA SP jack located on the rear panel when the transceiver is
used as a public address system. The speaker should be directed away from the
microphone to prevent acoustic feedback. Physical separation or isolation of the
microphone and speaker is important when operating the PA at high output
levels.
- 7 ~