Specifications – Uniden PRO 540e User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SPECIFICATIONS

Channels:

Frequency Range:

Frequency Control:
Frequency Tolerance;
Operating Temp.;
Microphone;

Input Voltage:

Current Drain:

Size;
Weight:

Antenna Connector;

LED Meter;

TRANSMITTER

Power Output;
Modulation:
Freq. Response:

Output Impedance;

RECEIVER

Sensitivity;

Selectivity;

Image Rejection;
I.F. Frequency;

RF Gain Control:

Automatic Gain:

Noise Blanker:

Squelch:

Audio Output Power:

Freq. Response;
Tone Boost:

Distortion:

Internal Speaker;

External Speaker;
PA System;

40 AM
26.965 to 27.405 MHz

Phase Locked Loop (PLL) synthesizer

0.005%
-30“C to +50“C
Plug in type; dynamic

13.8 VDC nom. (+ or — ground)

TX: full mod., 2.0A

RX: with max audio output, 1.2A

6 I 3 / 1 6 " W x 8 3 / 8 " D x 2 " H

3 lb. 2 oz.
UHF, SO-239
Indicates relative RF output and received sig­
nai strength and standing wave ratio.

4 watts
Class В amplitude modulation
300 - 3000 Hz
50 ohms, unbalanced

0.4/iV for lOdB; (S + N)/N typical (limit;
0.8,uV)

.

6dB @ 7KHz, 70dB @ lOKHz typical
80 dB typical

Double Conversion Superheterodyne

1st 10.695 MHz

2nd 455 KHz

Adjustable for optimum reception

(AGC); less than iOdB change in audio out­

put for inputs from 10 to 50,000 microvolts

RF type

Adjustable; threshold less than 1 fiV

7 watts max. into 8 ohms

300 to 3000 Hz

Lower: adjustable 10 dB @ 300 Hz
Upper: adjustable 10 dB @ 3000 Hz
less than 7% at 4 watts, 1000 Hz

less than 7% at 4 watts, 1 OOOHz
8 ohms, 7 watts round

[not supplied) 8 ohms
7 watts in external 8 ohm speaker

- 7 -

Advertising