Kenwood KS-303HT - Manual (Page 10)

Specifications
Front speaker. Center speaker. Rear speaker
Front speaker Center speaker Rear speaker
System 2 way
(Magnetically shielded)
2 way
(Magnetically shielded)
1 way
Enclosure Acoustic Air Suspension Acoustic Air Suspension Acoustic Air Suspension
Loudspeaker 100 mm(4”) Cone type
(Full Range type)
Woofer: 100 mm{4") Cone type 100 mm(4") Cone type —
Tweeter: 50 mm(2") Cone type 50 mm(2") Cone type —
Nominal Impedance SO. sa sn
Peak Input Power — sow SOW
Maximum Input Power SOW 40 W 40 W
Sensitivity 88 dB / W at 1 m 88 dB / W at 1 m 85dB/Wat1 m
Frequency Response 100 Hz~20,000 Hz 100 Hz~20,000 Hz 100 Hz~20,000 Hz
Crossover Frequency 3,000 Hz 3,000 Hz —
Dimensions Width: 129 mm(5-1/16") 129 mm(5-1/16") 129 mm(5-1/16")
Height: 198 mm(7-13/16") 198 mm(7-13/16") 198 mm(7-13/16")
Depth: 120 mm(4-3/4") 120mm(4-3/4") 120 mm(4-3/4'')
Net Weight 1.2 kg (2.6 lb) /piece 1.0 kg (2.2 lb) 0.8 kg (1.8 lb) /piece
Subwoofer
System Subwoofer system with built-in amplifier
c
o
+3
o
0)
(A
o
'S
3
<
Output Power
50 Watts RMS, at 4Q from 40 Hz to 160 Hz
with no more than 0.09% total harmonic distortion
Input Sensitivlty/Impedance
RCA-type pin-plug jack (LINE IN): 100 mV/43 kii, 200 mV/43 kQ (MONO)
Push-type terminals: 1.8V/1.2 kQ
Turn Over Frequency 80 Hz ~ 160 Hz
Phase Switching NORMAL, REVERSE
.2
(D
0) u
CL 0)
CO «
Enclosure Bass-Reflex
Loudspeaker 200 mm (8") Cone type
Nominal Impedance 4a
Frequency Response 40 Hz ~ 250 Hz
"<5
0>
c
0>
O
Power Consumption now
Supply Voltage AC120V, 60 Hz
Dimensions Width: 286 mm (11-1/4")
Height: 368 mm (14-1/2")
Depth: 356 mm (14")
Net Weight 11.2 kg (24.7 lb)
Enclosure Finish High density particle board laminated with simulated wood grain vinyl.
NOTE: THE GRILLES ON ALL THE SPEAKERS CANNOT BE REMOVED.
Notes: -------------------------------------- -—-— ----------- --- ---------------------------------------------------------------------------------------------------------
1. Kenwood follows a policy of continuous advancements in development. For this reason, specifications may be changed
withou notice.
2. Full performance may not be exhibited in extremely cold locations (below 0 deg. C).