Changing head cable orientation – Toshiba IK-542XD User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
14. CHANGING HEAD CABLE ORIENTATION
The output direction of the camera cable on the camera head can be changed from left
back (factory setting viewed in front of) to left side. Changing the output direction will
change wiring conditions inside the camera head, so be careful. Changing to right back or
right side is also possible, but consult with the service shop or service personnel in this
case.
(A) Output direction changing from left back to left side
Changing from left
back to left side
Procedures
Description on
procedures
Pull out in left back direction
Pull out in left side direction
h
1
T
1 Æ
t2
i
ili
^ H 4
1. Remove 2 screws (1 at
back side, 1 at front side)
2. Pull out cable bushing in
side direction (take care
not to damage internal
wiring leads).
(D
3. Insert cable bushing from
back side (take care not
to jam the cable).
4. Tighten the screws firmly.
Note:
Take care not to apply tension and torque to the wiring material inside the camera
head and the flexible PC board, it may cause break down of the wiring leads or dam
age the camera head.
22