Toshiba LF400 - Manual (Page 2)

iEntering value
:Selecting value
^Entering and selecting value
A •Factory default standard value table#
Code Item
o,..t
Changed value ...EXP,
A3 Excitation Freouency Vakie(ikl) value (*i)
24H2
Bl Indicating LHt 1 trfi/h gai/min
24HJ
62 Indicating Unit 2 % COUNT 2dht
C1 Range Type Sl^iGL£ siNae 3№ni(3Kfi) 24H2
C2 Range 1 Vaiue(«2) value <«2) ItOnnMncM 24h«
Oamoing Constant iseo 6seo
;? LOW Cutoff 1% 196
i 1 CX31 Function MOUSE PULSE OUT
“ThT
t-2 002 Function ootion(*4) (Mouse) Option(*4) (EmptyAir) 360nMI4rKti)
F3 Dl Function Ootion(*4) (RES/STA) Oplion(*4) <C RES/STA) «Omi(l6ix3V l2Hz
Gl Counting Rate 0 Value (*3)
Q2 Pulse Width OmS 5mS AiliAiU
II Hon Alarm Set OFF OFF
13 LOW Alami Set OFF OFF
J1 Empty Ppe Alarm ON (5N
K1 Rate-of-charge Limit 096 596
K2 Control Limit rne
r
• FRROR/AI AR
Error/ Alarm type Indicating message Error contents
Sett-diagnostics emx *RCW ERROR* ROM error
*RAU ERROR* RAM error
PARAMETER FAIL System parameter error
EX CURR. OPEN Excitation crcuit error
EX CURR. ERROR Excilaton current error
ADC. ERROR ADC error
IMVALO TOTAL Invalid totakaer counts 1
Settirg error *H OVER SPEC. Setting value exceeds the alowabie high Hrrii. 1
*L. OVER SPEC. Settirrg value exceeds the aHowabie low limit. 1
*H. OVER CRATE Counting rate exceeds the alowaOle high kmit. I
• L OVERCRATE Countino rate exceeds the alowaOle low kmit. 1
* MULTI RNG ERR Span is not appropriate for multkange configLration. 1
Limit ai»ms H, ALARM Flow rate reading exceeds the high Umit. I
L ALARM Flow rate reading goes below the low krit. 1
EMPTY Detector pipe is not filled with fluid. 1