Casio XJ-S31 - Manual (Page 15)

15
7 Enter a key sequence up to eight key operations long.
z You can use any of the following keys as part of your password key sequence.
[INPUT], [AUTO], [BLANK], [FREEZE], [COLOR MODE], [D-ZOOM +],
[D-ZOOM –], [KEYSTONE +], [KEYSTONE –], [MENU], [POINTER],
[ ], [
U
], [ ] , [
S],
[
T], [W], [X]
, [FUNC]
8 After entering the new password, press the [ENTER] key.
z This will display a dialog box prompting you to enter the same password again.
9 Re-enter the same password key sequence you entered in step 7 and then press
[ENTER].
z The message “Your new password has been registered.” indicates that the password has
been changed. Press the [ESC] key.
z If the password you entered in this step is different from the one you entered in step 7,
the message “The password you input is wrong.” appears. Press the [ESC] key to return
to step 7.
10 After you are finished, press the [MENU] key to exit the setup menu.
To turn password protection on and off
1 Display the Power On Password setting screen by performing steps 1 through 5
of the procedure under “To change the password” on page 14.
z At this time, make sure that “Power On Password” is selected on the Power On
Password setting screen.
2 Use the [
W] and [X] keys to select “On” or “Off”.
z Changing the power on password setting from “On” to “Off” causes the confirmation
dialog box shown below to appear.
Press the [ENTER] key to confirm that you want to turn on power on password
protection, or [ESC] to exit the dialog box without doing anything.
3 After you are finished, press the [MENU] key to exit the setup menu.
Entering the Password when Turning On the Projector
When you turn on the projector while password protection is turned on will cause a
password input dialog box to appear on the projection screen. All projector operations will
be accessible to you after you input the correct password and press the [ENTER] key.
Note
You can perform the projection size adjustment operation ([ZOOM +] / [ZOOM –] keys),
focus operation ([FOCUS
S] / [FOCUS T] keys), and power off operation ([
] key)
while the password input dialog box is on the projection screen.