VTech 900I - Manual (Page 23)

ïiid le^REGULATIONS
1C (Industry Canada)
This telephone is registered for use in
Canada.
Notice: The Industry Canada label
identifies certified equipment. This
certification means that the equipment
meets certain telecommunications
network, protective, operational and
safety requirements. Industry Canada
does not guarantee the equipment will
operate to the user’s satisfaction.
Before installing this equipment, users
should ensure that it is permissible to
be connected to the facilities of the
local telecommunications company.
The equipment must also be installed
using an acceptable method of
connections. The customer should be
aware that compliance with the above
conditions may not prevent degradation
of service in some situations.
Repairs to certified equipment should
be made by an authorized Canadian
maintenance facility designated by the
supplier. Any repairs or aiterations
made by the user to this equipment, or
equipment malfunctions, may give the
telecommunications company cause to
request the user to disconnect the
equipment.
Users should ensure for their own
protection that the eiectrical ground
connections of the power utility,
telephone lines and internal metallic
water pipe system, if present, are
connected together. This precaution
may be particularly important in rural
areas.
Caution; Users should not attempt to
make such connections themselves,
but should contact the appropriate
electric
inspection authority, or
electrician, as appropriate.
The Load Number (LN) assigned to this
device denotes the percentage of the
total load to be connected to a telephone
loop which is used by the device to
prevent overloading. The termination
on a loop may consist of any
combination of devices subject only to
the requirement that the total of the
load numbers of all the devices does
not exceed 100.
This device complies with RSS-210 of
Industry Canada. Operation is subject
to the following two conditions: (1) this
device may not cause interference, and
(2) this device must accept any
interference, including interference that
may cause undesired operation of the
device.
42
TECHNICAL SPECIFICATIONS
FREQUENCY CONTROL
Crystal Controlled Dual PLL
Synthesizer
TRANSMIT FREQUENCY
Handset : 925.05MHzto927.75MHz
(All ten channels within this
range)
Base : 902.3 MHz to 905.0 MHz
(All ten channels within this
range)
RECEIVE FREQUENCY
Handset : 902.3 MHz to 905.0 MHz
(All ten channels within this
range)
Base : 925.05MHzto927.75MHz
(All ten channels within this
range)
NOMINAL EFFECTIVE RANGE
Maximum power allowed by FCC and
1C. Actual operating range may vary
according to environmental conditions
at the time of use.
WEIGHT
Handset : 345 grams (with battery)
Base
: 1075 grams(with AC
adapter)
SIZE
Handset : 20.0cm x 6.2cm x 4.3cm
(L X W X T) maximum
(antenna excluded)
Base : 22.0cm X 19.5cm X 6.1cm
(L X W X T) maximum
(antenna excluded)
POWER REQUIREMENTS
Handset ; Self-contained nickel­
cadmium rechargeable
battery supply, 6.0V
nominal, 600mAh
capacity.
Power Adapter: 12VDC @ 500mA
SPECIFICATIONS ARE TYPICAL
AND MAY CHANGE WITHOUT
NOTICE.
The range quoted for this phone is
based on open field measurements
under (deaf conditions.
43