Califone M319 - Manual (Page 2)

2
Product Compatibility
The M319 Beltpack Transmitter (and Q319
Microphone) are compatible with the PA919SD,
PA919, PA919PS PAs. They are not compatible
with the PA916 series PAs or the M-316 or Q-316
microphones.
Warranty Registration
The warranty for the M319 specifically
covers use in schools, churches, and business
& industry applications, unlike consumer
electronic products. This is critical to help avoid
lost class time due to “down” equipment and
helps stretch budgets.
Califone warrants the M319 to be free from
defective material and workmanship for one
year from the purchase date. Our “Project
Intercept” Customer Satisfaction program will
replace defective parts and repair malfunctioning
products under this warranty when the defect
occurs under normal use, provided the unit is
returned to our factory via prepaid transportation
only after the factory issues an RA
(Return Authorization) number which
must be clearly written on the outside
of the shipping box.
All Damage Claims Must Be Made
With The Freight Carrier
Notify the freight carrier immediately if you
observe any damage the shipping carton or
product. Repack the unit in the carton and
await inspection by the carrier’s claim agent.
Notify your dealer of the pending freight claim.
Returning your unit for service or repairs
Should your unit require service, contact your
dealer or our Customer Service Department
directly via email ([email protected]), or
by phone at 800-722-0500 / 818-407-2400 to
first obtain a Return Authorization (RA) number
before sending it back to Califone.
Damage Requiring Service
The M319 should be serviced by
qualifed service personnel when:
• Objects have fallen on it or liquid
has been spilled onto it
• It has been exposed to rain
• It does not appear to be operating
normally or exhibits a marked
change in performance
• It has been dropped or the
enclosure damaged
All shipments to Califone must include the
RA number clearly marked on the exterior of
the shipping carton and must shipped prepaid.
C.O.D. shipments will be refused and returned
at your cost.
Servicing
The user should not attempt to service
the M319 beyond that described in these
operating instructions.
3
Operating Instructions:
The microphone frequency must first be set to
the same frequency as the receiving PA.
1. Open th battery cover and insert a 9V battery
(not included) into battery compartment.
Close the battery cover.
2. Adjust the volume knob to minimum.
3. Connect one of the Califone microphones
(shown on pages 3 & 4) to the 3.5mm
mic input jack. The M319 can accept
dynamic or electret microphones.
4. Turn on the M319 power switch. The LCD
will display the current transmit channel.
5. To change the transmit channel:
• Use a pen to hold the channel down 
button for about 3 seconds.
• The transmit channel will begin to flash
on the LCD.
• Release the down button. 
• Then use the up/down buttons to change
to the desired transmit channel.
• After about 3 seconds the transmit
channel will be set and the channel on
the LCD display will be solid.
• Make sure the transmit channel is not being
used by any other transmitters in the area or
there could be audible interference. If there
is any interference or distortion, try using a
different channel.*
6. Set the Califone receiver to the same
channel as the transmitter.
7. Turn on the receiver and first adjust its
volume level.
8. Then turn the M319 on and adjust its volume
level to the desired level.
* Since the PA919SD and PA919 each have
two built-in wireless receivers, make sure the
corresponding M319 (or Q319) transmitters are
set to different frequencies (one for
each channel).
Power Adjustment (Optional):
1. The power output of the M319 can be
adjusted between low (5mW) and high
(10mW) power settings, depending on the
level of interference or the range of required
transmission (low power up to 40’/high
power up to 200’). When there may be
other PA products used in neighboring or
adjoining rooms, using the low setting will
reduce the occurrence of experiencing
any interference.
2. With the power off, simply change the
transmit power by moving the switch to
the desired setting.
LM-316
CM-316
4
Specifications
Carrier Frequencies 902 ~ 928 MHz (16 channels)
Modulation FM
Frequency Stability ±5KHz
Transmitting Power Switchable: 5dBm / 10dBm
Spurious Rejection >55dB
AF Modulation Depth 20K (AF=1KHz50MV)
Volume Code Modulate Depth 3.5K ± 0.5K
AF Frequency Response 80HZ~18KHz (±3dB)
S/N >90dB
Distortion <1% (AF=1 KHz)
Dynamic Range >90dB
Transmission Distances High setting – approximately 200 feet
Low setting – approximately 40 feet
Operating Voltage DC 6V~9V
Current <42MA
Safety / Compliance Testing FCC, RoHS
Battery Requires 9V battery (not included)
Operational Temperature -10 o C to +60 o C
Input Jack 3.5mm
NM-316
visit us online at califone.com | califonepro.com visit us online at califone.com | califonepro.com
OE-316
HBM-316
M319_manual.indd 2 6/22/09 1:11 PM