Playback connections – RCA CC-285 User Manual

Page 40

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Playback Connections

How to Connect Your Camcorder to a Standard TV (without

A UDIO/ VIDEO

input jacks)

for Playback

Antenna

^

Camcorder

page 39 if you have a monitor/
receiver with input jacks.

You will need the

RF output adapter

and

coaxial RF cable

that came

packed with your camcorder. If your
antenna cable is the flat twin-lead

type that is attached by two screws,

you will also need the

300/ 75-ohm

transformer.

(T) Disconnect the VHF antenna

from your TV set. (You can
leave the UHF wires alone.)

(T) Connect your VHF antenna to

the RF input adapter. (This step
is not necessary unless you plan
to leave the RF adapter hooked
up to your TV set.)

A. If your antenna cable is a

round 75-ohm cable, connect
it to the

ANT

connecter on

the RF adapter.

B. If your antenna cable is a flat

twin-lead, you will need the
300/75-ohm transformer that

was packed in your
camcorder. Connect the flat-

lead connectors to the screw
terminals on the 300/75-ohm
transformer. Then connect the
transformer to the

ANT

connector on the RF adapter.

Connect the other end of the

coaxial RF cable to the

VHF

terminal on the back of your TV.
(If your TV has VHF screw
terminals, connect the adapter’s
flat-lead connectors to the screw
terminals.)

Plug the multi-pin connector
fitting on the RF adapter into
the ot/r jack on the
camcorder. To aid connection,
match the tabs on the fitting
with the notches on the
camcorder jack. Don’t force the
fitting. If it does not slide in
easily, check your marks and try
again. (If the camcorder is used
as a camera while connected to
the TV, be sure to turn the set’s
volume down to prevent a high-
pitched squeal caused by
feedback.)

Set the switch on the RF adapter
to channel 3 or 4, whichever is
not used as a broadcast channel
in your area. Turn on the TV
and tune it to the channel you
have chosen.

operation, refer to page 40.)

For normal TV viewing, you may
leave the RF adapter hooked up
to the TV set. Just disconnect the
adapter from the camcorder or
turn off the camcorder’s power.

38

Advertising