Set-up using code search – RCA RCU400R3 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Set-Up Using Code Search
Follow the steps below to set up your remote using the
Code Search method. If you complete these steps and
your device does not respond, follow the Code List
method for your device.
Programming a Device using
CODE SEARCH
1. Manually turn on your device
(TV, VCR, Cable Box).
2. Press and hold
CODE SEARCH.
PRESS
&H0LD
CODE
SEARCH
AUX CABLE VCR TV
3. Press and release the device button
you want to set up (TV, VCR, or fl fl fl fl
CABLE). If you are using AUX for a
device, press and release AUX, then
the device button for the type of
device to be programmed (TV,
VCR, or CABLE). The selected
device button will flash once.
4. Release
CODE SEARCH.
RELEASE
CODE
SEARCH
(D
5.
Press
OFF/ON
repeatedly until the
device turns off
(Important: you
may have to press up to 100 times
at a rate of once per second).
OFF/ON
6. Once the device turns off,
press and release
ENTER.
ENTER
With the device on, press another
button, for example
CHANNEL UP.
If the device responds, no further
programming is required. If the
device does not respond, repeat
steps 1-7.
CHAN
11