Chrysler 2008 Sebring Sedan - Manual (Page 102)

Three-Way Calling
To initiate three-way calling, press the “Voice Recogni-
tion” button while a call is in progress, and make a
second phone call, as described under
ЉMaking a Second
Call While Current Call in Progress. Љ After the second call
has established, press and hold the PHONE button until
you hear a double beep, indicating that the two calls have
been joined into one conference call.
Call Termination
To end a call in progress, momentarily press the PHONE
button. Only the active call(s) will be terminated and if
there is a call on hold, it will become the new active call.
If the active call is terminated by the far end, a call on
hold may not become active automatically. This is cell
phone-dependent. To bring the call back from hold, press
and hold the PHONE button until you hear a single beep.
Redial
• Press the PHONE button to begin.
• After the ЉReadyЉ prompt and the following beep, say
ЉRedial.Љ
• The UConnect௡ system will call the last number that
was dialed from your cellular phone.
NOTE: This may not be the last number dialed from the
UConnect
௡ system.
Call Continuation
Call continuation is the progression of a phone call on the
UConnect
௡ system after the vehicle ignition key has been
switched to OFF. Call continuation functionality avail-
able on the vehicle can be any one of three types:
• After the ignition key is switched to OFF, a call can
continue on the UConnect ௡ system either until the call
ends, or until the vehicle battery condition dictates
cessation of the call on the UConnect
௡ system and
transfer of the call to the mobile phone.
100 UNDERSTANDING THE FEATURES OF YOUR VEHICLE