Chrysler 2008 Country - Manual (Page 486)

Rear Tail, Stop, Turn Signal, Side Marker and
Backup Lights
1. Raise the liftgate.
2. Remove the tail light assembly by removing the two
screws from the inboard side. Use a fiber stick or similar
tool to gently pry the light on the outboard side to
disengage the two ball studs.
NOTE:
• If a screwdriver is used, make sure a soft material is
placed between the vehicle body and tool so not to
scratch the paint.
• The PRY location is best closest to the studs while
dislodging them separately.
Removing Tail Light Assembly
1 — Stop, Tail, Turn Signal bulb combo 2 — Backup Bulb
484 MAINTAINING YOUR VEHICLE