Chrysler 2013 200 Convertible - User Guide - Manual (Page 15)

NOTE:
Route the tether strap to provide the most direct path from the child seat to the anchor.
• From inside the trunk, open the access cover on the carpet covering the back of the seat and
attach the tether strap hook to the anchor.
• Tighten all three straps as you push the child
restraint rearward and downward into the seat.
Installing The Child Restraint Using The Vehicle Seat Belts
• To install a child restraint, first pull enough of the seat belt webbing from the retractor to route
it through the belt path of the child restraint and slide the latch plate into the buckle.
• Next, extract all the seat belt webbing out of the retractor and then allow the belt to retract into
the retractor. Finally, pull on any excess webbing to tighten the lap portion around the child
restraint. Any seat belt system will loosen with time, so check the belt occasionally, and pull it
tight if necessary.
• If lowered, raise the convertible top.
NOTE:
The convertible top must be in the UP position to access the tether anchor.
• Open the access port cover behind the seat where you are placing the child restraint. The access
ports to the top tether anchorages are directly behind the seat headrests under a plastic cover.
• Push the tether strap and hook through the access port and down into the trunk.
G E T T I N G S T A R T E D
13