CLEAR PC Card - Manual (Page 13)

9 Installing and using Clearwire pc card 10
Regulatory Requirements
The Federal Communications Commission (FCC) requires application for certification of
digital devices in accordance with CFR Title 47, Part 15 and Part 27. This includes
Electromagnetic Energy Exposure (EME) testing. As the PCC-2510 is not a stand-alone
modem but is a PC card, the PCC-2510 cannot be tested by itself for EME certification and
was tested while inserted in a laptop computer.
Modification of this device may void the user’s authority to operate this equipment.
When using the PCC-2510 product, other wireless networking devices contained within the
laptop computer must be disabled. For example, most modern laptop computers contain
wireless networking functions that are integrated into the computer which utilize a Wi-Fi or
WLAN protocol product such as [email protected] and 802.11b/[email protected].
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
NOTE : The PCC-2510 was approved by the United States Federal Communications
Commission (FCC) for use with the integral antenna and optional external accessory antenna
which is available from your service provider.
NOTE: Safety and General Information
IMPORTANT INFORMATION ON SAFE AND EFFICIENT OPERATION.
READ THIS INFORMATION BEFORE USING YOUR MOTOROLA PCC-2510.
Antenna Care
Use only the supplied or an approved replacement antenna. Unauthorized antennas,
modifications, or attachments could damage the radio product and may violate FCC
regulations. When using any approved accessory antenna, position it at least eight inches
(20cm) from any part of any person.
DO NOT hold the antenna when the radio product is “IN USE”. Holding the antenna
affects communication quality and may cause the product to operate at a higher power
level than needed.
RF Operational Characteristics
Your Motorola product contains a radio frequency transmitter to convey the information you
wish to send as well as occasional automatic signals used to sustain connection to the wireless
network, and a receiver which enables you to receive communication and connection
information from the network.