COMEUP DHC Hoist (Ver:03) - Manual (Page 5)

I . Safety Requirement
The operator of a hoist in some cases is required to have qualifications according to applicable
laws and ordinances.
Check all safety and environmental conditions prior to and during use.
Don’t use unsuitable rope in construction, strength or having any defects.
Don’t use an unsuitable hook and snatch block for rope.
The operator must remain with the hoist when it is being operated.
The hoist is rated at S3 Intermittent duty only.
Do not use the hoist as moving people.
Ensure that the hoist is connected to the correct voltage. 12V DC or 24V DC only.
Do not exceed maximum line lifting shown in tables. Shock load must not exceed these ratings.
A rope should be replaced if it shows signs of excessive wear, broken strands, corrosion or
any other defects.
If the hoist fails to lift a load under normal conditions, stop the operation within 30 seconds
otherwise motor damage may occur.
Remove the switch from the hoist when not in use.
Keep hands and clothes away from the hoist and rope.
Never unplug the remote control when hoisting a load.
To avoid insufficient power when hoisting a load, the vehicle should be running and in neutral.
If noise or vibration occurs when running, stop the hoist immediately and return it for repair.
The rope shall be wound in according to drum rotation sticker or refer to owners manual.
3
！
！
！
！
！
！
！
！
！
！
！
！
！
！
！
！
！
General Rules
！
WARNING
1. The owner and/or the operator shall have an understanding of these
operating instructions and the warning before operating the electrical hoist.
Failure to follow these warnings may result in loss of load, damage to the
hoist, property damage, personal, or fatal injury.
2. The owner shall retain this manual for further reference to important
warnings, installation, operating and maintenance instructions.