COMEUP Electric Winch (Ver:02) - Manual (Page 11)

9
Grounding
To prevent the risk of electric shock, the power plug must be plugged into a matching outlet
and grounded in good condition.
Up and Down Switching
To lift a load, press ↑ button and drum will rotate as shown below operation.
To lower a load, press ↓ button and drum will rotate as shown below.
To stop winching, release ↑or ↓ button.
To have an emergency stop function, press the emergency stop button (option). Rotate the
button clockwise for returning.
Wire Rope Replacement
● Insert the wire rope into the hole of drum and fix it with a P. T. screw, then press ↑ button
of switch for rotate the drum in the lifting direction.
● Wind the wire rope accurately around the drum, and an irregular winding will cause the load
to be swing, thus damaging the wire and reducing the life of winch.
● When replacing the rope w/weight hook for winch rated less than 500 kg, according to the
following procedures.
*Pull out an R-dowel "D" from the round head pin "C".
*Pull out a round head pin "C" from hook body "A".
*Put a wire rope "B" into the hole of hook body "A", and insert a round head pin "C" through
wire rope and fixture hole of hook body "A".
*Insert an R-dower "D" into the hole of round head pin "C".
Wire drum
Wire rope
Lifting direction
Down button
Wire drum Rotation
(Lifting direction)
DOWN
Up button
Wire drum Rotation
(Lifting direction)
UP