Comtrol MC7001 - Manual

Note: After adjusting the DIP-switch, reboot the MC7001 to activate the new settings.
DIP 4
DIP 3
DIP 2
DIP 1
4
NO
123
Pin Nr. # Status Description
Off Set Switch converter mode. (Default)
ON Set pure converter mode.
Off Set Fiber port in Full-duplex mode. (Default)
ON Set Fiber port in Half-duplex mode.
Off Set RJ45 in Auto-Negotiation mode. (Default)
ON Set RJ45 in 100Mbps Full-duplex mode.
Off Disable Link Loss Forwarding function. (Default)
ON Enable Link Loss Forwarding function.
DIP Switch Setting
LED Functions
TP
PW
LED Function
Lit when the MC7001 has proper input power and is operational.
Lit when the Ethernet connection is established on the RJ45 port.
Blinks when data is transmitted or received on the RJ45 port.
Lit when the fiber Ethernet connection is established on the fiber port.
Blinks when data is transmitted or received on the fiber port. FX
2 0 0 0 5 0 5 R e v. B w w w. c o m t r o l . c o m
Quick Installation Guide
www.comtrol.com 2000505 Rev. D
Comtrol Customer Service
Contact Method Web Address or Phone Number
Support http://www.comtrol.com/pub/en/support
Downloads ftp://ftp.comtrol.com/html/default.htm
Web Site http://www.comtrol.com
Phone 763.957.6000
4 5
The following table provides information about optical fiber cable attenuation:
Fiber Type Wavelength Attenuation /km *1 Attenuation /km *2 Connector
Loss
Splice
Loss
Multi-Mode
50/125um
850nm
1310mm
3.5dBm
1.5dBm 2.5dBm
0.8dBm 0.75dBm
0.1dBm
Multi-Mode
62.5/125um
850nm
1310nm
3.5dBm
1.5dBm 3.0dBm
0.7dBm 0.75dBm
0.1dBm
Single-Mode
9/125um 1310nm 0.4dBm 0.35dBm 0.75dBm 0.1dBm
Single-Mode
9/125um 1550nm 0.3dBm 0.22dBm 0.75dBm 0.1dBm
*1. These values are per TIA/EIA and other industrial specifications.
*2. These values are an example of the performance that can be obtained with a new fiber installation.
ROCKET LINX MC7001
Industrial Ethernet to Fiber Media Converter