Changing device properties – Comtrol NS-link Windows NT User Manual
Page 55
Device Configuration
55
Changing Device Properties
3.
Select the IP Programming tab.
4.
Select the Disable button.
Note: Not available on all NS-Link devices. If the button is greyed out, then
this feature is not available.
5.
Select the Reset button and wait until the device reloads.
Note: The Comtrol device cycles its LEDs.
6.
Select Ok to close the Device window.
7.
Select Ok to close the Properties window.
8.
Close the Device Manager or the Network Property page (depending on the
operating system).
Changing Device Properties
After installation and configuration, you may want to change device properties,
such as the device name or configure the KeepAlive Time-out Period or the TCP
Time-out Multiplier. Use the following to change these values.
1.
Access the Properties page for the device using the appropriate procedure:
Windows XP and Windows 2000:
a.
Right-click My Computer, select Manage, and highlight Device Manager.
b.
Expand the Multi-port serial adapters entry, right-click on the device you
are configuring, and select the Properties menu item.
Windows NT:
a.
Right-click on the Network Neighborhood, and select Properties.
b.
Select the Adapters tab.
c.
Highlight Comtrol NS-Link and select the Properties button.