Review the options and make any desired changes, Tcp client, From the start menu, select the run command – Comtrol DM Primo for Pair Connect and Raw Connect Methods User Manual
Page 15
DeviceMaster Primo for Pair and Raw Connect Methods
15
TCP Client
10. Press the Esc key twice to return to the main menu. Select the Monitor
option.
11. Review the options and make any desired changes.
Note: The Connection Status is set to listen. After you restart the device, the
TxChar Count and the Rx Char Count fields display data transfer
activity.
12. Press the Esc key to return to the menu. Select the Restart option to save any
changes.
TCP Client
This Raw connection is an active client (TCP Client) that requests the TCP
connection to the specific host for data transmission. The host reads or writes the
serial data bi-directionally after the TCP connection has been established.
1.
From the Start menu, select the Run command.
2.
Type Telnet plus the Primo IP address, and select the OK button.
3.
Confirm that it is a vt100 session, and press the Enter key.