ConvertiBARS Ducati: ST-3(04+) - Manual

Ducati ST-3(04+)
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to
set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike
Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with
out pulling taught or kinking any lines, and without damaging any part of the motorcycle
Important Installation Considerations
Simplr install. Some creative routing of lines is necessary.
Recommended Riser Trim Length
1. 8.0" Riser Length = No Trimming
Recommended parts and replacement lines
1. Hydraulic Brake Line Top Fitting - 000(Straight)
2. Hydraulic Brake Line = Stock + 3"
3. Throttle Lines - Ok rerouted
4. Throttle Lines - Stock + 2"
5. Hydraulic Clutch Line = Ok