ConvertiBARS Honda: VFR-800(02-09) ABS - Manual

Honda VFR-800(02-09) ABS
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to
set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike
Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with
out pulling taught or kinking any lines, and without damaging any part of the motorcycle
Important Installation Considerations
Special Kit Requirements/Installation Tips
1. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing
2. Cyclops Clamps - are to be mounted on top of the triple clamp
3. Cyclops Clamps - Flipping the clamps upside down from what is in the
instruction book, may offer more convertibility and better fitment.
Restrictions
1. Upper fairing and or windshield can be trimmed for more rise.
Line Routing
1. Brake Line - Ensure line(s) and top fitting position does not interfere with
instrument panel, riser, Cyclops Clamp, and or brake lever.
2. Throttle Lines - Take special care when routing to avoid interference with riser
pipe
3. Throttle Lines - Longer than stock - route as stock
4. Clutch Line - Longer than stock - route as stock
Recommended Riser Trim Length
1. 5.0" Riser Length = Trim Number 8
Recommended parts and replacement lines
1. Honda VFR-800(02+) Stock+75mm length Throttle Lines. Part Numbers- X-633,
07-0806. Order from ConvertiBARS
2. Hydraulic Brake Line Top Fitting - 90 degree face to the side
3. Hydraulic Brake Line = Stock + 3"
4. Throttle Lines - Stock + 2"
5. Horn wire extension
6. Hydraulic Clutch Line Top Fitting - 90 degree face to the side
7. Hydraulic Clutch Line = Stock + 2"