ConvertiBARS Kawasaki: ZRX-1100/1200 - Manual

Kawasaki ZRX-1100/1200
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to
set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike
Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with
out pulling taught or kinking any lines, and without damaging any part of the motorcycle
Important Installation Considerations
Special Kit Requirements/Installation Tips
1. Cyclops Clamps - Flipping the clamps upside down from what is in the
instruction book, may offer more convertibility and better fitment.
Restrictions
1. Foreword Positions restricted by instrument panel
Recommended Riser Trim Length
1. 8.0" Riser Length = No Trimming
Recommended parts and replacement lines
1. Hydraulic Brake Line = Stock + 3"