ConvertiBARS Kawasaki: ZX-14R (2006+) User Manual
ConvertiBARS For motorcycles
Kawasaki ZX-14R (2006+)
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to
set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike
Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with
out pulling taught or kinking any lines, and without damaging any part of the motorcycle
Important Installation Considerations
Cyclops Clamps fit on top of the triple clamp which requires raising the forks
about .5". No rise with the stock brake line.
Special Kit Requirements/Installation Tips
1. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing
2. Cyclops Clamps - are to be mounted on top of the triple clamp
3. Cyclops Clamps - Flipping the clamps upside down from what is in the
instruction book, may offer more convertibility and better fitment.
Recommended Riser Trim Length
1. 5.0" Riser Length = Trim Number 8
Recommended parts and replacement lines
1. Hydraulic Brake Line = Stock + 5"