Radio noise troubleshooting – C. Crane Twin Coil Ferrite User Manual

Page 12

Advertising
background image

Page 12

Twin Coil Ferrite

AM Antenna by C.Crane

Radio Noise Troubleshooting

AM RADIO NOISE PROBLEMS

AND POSSIBLE SOLUTIONS

If you hear an annoying buzz when listening to AM radio, it’s most likely
radio noise. Here are some of the usual culprits:

• Dimmer switch (even in an adjacent room).

• Lights: fluorescent light, "touch lamp" type fixtures, automatic

night lights, motion-activated outdoor lights, dying bulbs,
blinking bulbs.

• Nearby television or computer.

• Electronic bug and pest controllers.

• Faulty electrical switch.

• Radios & scanners.

• Dirty insulators on a nearby power pole.

• Electric blanket.

• Smoke detectors that run from an AC current (battery operated

units are OK).

Now what can you do about it?

• Turn off the circuit breakers to see if the noise stops, and if the

source comes from inside your house. Turn off one circuit at a
time to isolate the source of the noise.

• Using a battery-operated radio, check if the interference comes

from the AC 120V line, through the air, or both. To locate the
direction of the noise, turn the radio until you hear the loudest
noise. The front and the back of the radio will point to the noise
origin.

• If the noise comes from outside, carry the radio around the

neighborhood to check for the origin of the noise. Ask your
neighbors if they hear the same noise.

• If you suspect a power pole, call the utility company. Dirty

power pole insulators are sometimes a cause of hard-to-find
radio interference.

• Sometimes grounding can greatly reduce the hum from AC line

noise. Unfortunately, most radios do not have a ground
connection. Finding a good earth ground may also be difficult.

For more detailed information, please visit

www.ccrane.com/radionoise

Advertising
This manual is related to the following products:

TCA