Cooler Master Glacer 240L - Manual (Page 2)

Specifications
Packing List
Intel® LGA 1366/1150/1156/1155/775 Back-Plate Installation
1. Remove the back bracket from the
waterblock by loosening all 4 screws.
Do not misplace as it is needed later.
2. Move each of the adjustable standoffs
in position:
LGA 1366: 100% g out
LGA 775: 100% f in
LGA 1150/55/56: ~20% g out
3. Remove the 4 adhesive foam pads.
4. Place the back plate on the bottom of
motherboard making sure to align the
standoffs with the motherboard holes.
The CPU cooler can now be mounted
to the motherboard.
SOCKET 2011 Install:
Please remove the nylon retaining
washer from each spring-loaded screw
by snapping out of its groove, and set
aside for future installations/upgrades.
Install the provided Intel® LGA 2011
spring-loaded screws. Secure each
spring-loaded screw to the bracket by
snapping a nylon retaining washer into
the groove of each screw body.
5. Apply Thermal Paste to top of CPU in
a thin even layer.
6. Remove the protective film on bottom
of CPU cooler.
Material Brass Tubes, Copper Fins
Body Dimensions 269mm x 127mm x 29mm / 10 19/32” x 5” x 1 9/64”
Fill-Port thread G1/4
Dimensions 120mm x 120mm x 25mm
Speed 2400 RPM
Airflow 86.15 CFM
Static Pressure 0 → 2.65 mH20
Noise Level 16 → 40.33
Connector 4-Pin PWM
Speed PWM adjustable 1200 ~ 3500 RPM
Voltage 12v
Connector 4-Pin PWM, SATA power connector
Radiator
Fan
Pump
Tubing
CPU Socket Compatibility
Material PVC
Dimensions 5/8” x 3/8” (16/10mm)
Intel® LGA 1366, 1150, 1155, 1156, 775, 2011
AMD® AM2/(+), AM3/(+), FM1, FM2, 939
Intel® Back Plate x 1 LGA 2011 Spring Loaded Screws x 4
Glacer 240L LCS (radiator,
120 mm fan x 2, tubing, waterblock
with pump)
AMD® Bracket with screws x 2 Thermal Paste x 1 Radiator Mounting Screws x 8
Proceed to Radiator and Pump Mounting on back →
See online for refilling instructions
and additional information.