Setting the angle of the ultima bath chair, Adjustments to the ultima, Should not be made while in use – Columbian Ultima 8520 User Manual
Page 2
Ultima Assembly Instructions Rev
2/07
Setting the Angle of the Ultima Bath Chair
The Ultima bath chair is easy to adjust using the four simple adjustment lever bars, located on the front leg,
back leg, under the cover of the chair back and under the cover of the Chair calf support. The legs, calf
support and back angles each adjust independently.
Adjustments to the Ultima
™
should not be made while in use.
Adjusting Back Angle:
Locate the adjustment lever bar on the chair back, under the cover (you do not need to remove the cover to
operate the lever), and simply grip the lever and seat frame back and squeeze together. Then, with a lifting
motion, adjust the back angle up or down.
Adjusting Calf Support Angle:
Locate the adjustment lever bar on the chair calf support, under the cover (you do not need to remove the
cover to operate the lever), and simply grip the lever and seat frame back and squeeze together. Then, with a
lifting motion, adjust the back angle up or down.
Adjusting Legs:
Locate the adjustment lever bar on each leg where it crosses the non-slip pads. By gripping the lever and
pads, squeeze together and with a lifting motion, adjust the angle up or down.
Warning:
The legs should
never be used in the most upright position.
ADJUSTING ANY HIGHER THAN MAXIMUM LEG HEIGHT ADJUSTMENT
WILL CAUSE THE CHAIR TO BECOME UNSTABLE WHILE IN USE
Maximum leg height position -90° position, do not use
INSE-85-20
2-3