Crosman ASM14B - Manual

M14 Airsoft Spring Rifle
6mm Plastic BBs
OWNER’S MANUAL
READ ALL INSTRUCTIONS AND WARNINGS IN THIS MANUAL BEFORE USING THIS AIRSOFT GUN
Marine Corps trademarks used under license by Crosman Corporation.
Distributed by:
Crosman Corporation
7629 Routes 5 & 20,
Bloomfield, NY 14469
United States of America
www.crosman.com
1-800-724-7486
Made in China M14A515
THIS IS NOT A TOY. ADULT SUPERVISION IS REQUIRED. MISUSE MAY CAUSE SERIOUS INJURY, PARTICULARLY TO THE EYE. EYE
PROTECTION MUST BE WORN BY THE USER AND ANY PERSON IN RANGE. MAY BE DANGEROUS UP TO 100 YDS. READ THE OWNER’S MANUAL BEFORE USING.
DO NOT BRANDISH OR DISPLAY THIS AIRSOFT GUN IN PUBLIC – IT MAY CONFUSE PEOPLE AND MAY BE A CRIME. POLICE AND
OTHERS MAY THINK IT IS A FIREARM. DO NOT CHANGE THE COLORATION AND MARKINGS TO MAKE IT LOOK MORE LIKE A FIREARM. THAT IS DANGEROUS
AND MAY BE A CRIME.
THIS PRODUCT CONTAINS A CHEMICAL KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND BIRTH DEFECTS (AND OTHER
REPRODUCTIVE HARMS).
YOU AND OTHERS WITH YOU SHOULD ALWAYS WEAR SHOOTING GLASSES TO PROTECT YOUR EYES. READ ALL INSTRUCTIONS BEFORE USING.
THIS AIRSOFT GUN IS INTENDED FOR USE BY THOSE 16 YEARS OF AGE OR OLDER.
BUYER AND USER HAVE THE DUTY TO OBEY ALL LAWS ABOUT THE USE AND OWNERSHIP OF THIS AIRSOFT GUN
Please read this owner’s manual completely. Remember to treat this airsoft gun with the same respect you would a firearm. Always carefully follow the safety instructions found in this
owner’s manual and keep this manual in a safe place for future use.
If you have any questions regarding your new airsoft gun, please contact Crosman Customer Service at: 1-800-724-7486, 585-657-6161 or www.crosman.com.
1. Learning the Parts of Your New Airsoft Gun
Learning the names of the parts of your new airsoft gun will help you to understand your owner’s manual. Use thismanual to increase your enjoyment of this airsoft gun
A. Barrel
B. Muzzle
C. Rear Sight
D. Front Sight
E. Safety (Fig. 2A & 2B)
F. Magazine Release
G. Trigger
H. Magazine
I. Bolt (cocking handle)
J. Sling Mount
K. Stock
2. Operating the Safety
Keep the airsoft gun in the “ON SAFE” position until you are ready to shoot. Then turn the safety to the “OFF SAFE” position. Pix of the Trigger and
Safety, note on pix stating “ON SAFE”, 2A
A. To Put the Airsoft Gun “ON SAFE”:
• Locate the safety near the trigger. (Fig. 2A)
• Move the safety lever to the rear until the latch fully stops.
Like all mechanical devices, an airsoft gun safety can fail. Even when the safety is “On Safe”, you should continue to handle the airsoft gun
safely. NEVER point the airsoft gun at any person. NEVER point the airsoft gun at anything you do not intend to shoot
B. To Take the Airsoft Gun “OFF SAFE”
• Locate the safety near the trigger. (Fig. 2B)
• Move the safety lever to the front until the latch stops.
• The airsoft gun is “OFF SAFE” and ready to fire when the safety lever is moved to the front, outside the trigger guard
3. Loading and Unloading Plastic BBs
Use 6 mm airsoft BBs only in this airsoft gun. Use of any other ammunition can cause injury to you or damage to the airsoft gun. NEVER
RE-USE AMMUNITION.
A. Loading Plastic BBs
• Make sure the airsoft gun is “ON SAFE” (See Section 2.A) and pointed in a SAFE DIRECTION.
• While supporting the BB magazine, push the magazine release lever forward and remove the magazine (Fig. 3A).
• Slide open the reservoir door (Fig. 3B).
• Fill the reservoir with up to 200 BBs and slide the door closed.
• Locate the BB guide on the front of the magazine. Pull the BB guide down and hold in place with thumb or finger.
• Holding the magazine as shown, shake the magazine until up to 18 BBs feed into the magazine (Fig. 3C).
• Slowly release the BB guide.
• Insert the loaded magazine back into the receiver until you hear a click, indicating the magazine is securely locked into place.
IMPORTANT: The magazine will not automatically fill from the reservoir. You will have to remove the magazine and shake BBs from the
reservoir into the magazine after the magazine is empty.
B. UNLOADING PLASTIC BBS WITHOUT FIRING
• Make sure the airsoft gun is “ON SAFE” (section 2A).
• Point the airsoft gun in a SAFE DIRECTION.
• While supporting the BB magazine, push the magazine release lever forward and remove the magazine.
• Locate the BB guide on the front of the magazine. Pull the BB guide down and hold in place with thumb or finger.
• Holding the magazine horizontally, slide open the reservoir door.
• Empty the BBs from the reservoir into your hand or a container.
• Rock the clip to release the BBs from the magazine into the reservoir.
• Repeat the steps above until all the BBs are out of the reservoir.
EVEN THOUGH YOU GO THROUGH THE UNLOADING PROCEDURE, CONTINUE TO TREAT THE AIRSOFT GUN AS THOUGH IT WERE
LOADED. DO NOT POINT AT ANYTHING YOU DO NOT INTEND TO SHOOT.
4. Cocking the gun
Note: You must cock the airsoft gun before each and every shot.
• Make sure the airsoft gun is “ON SAFE” (See Section 2.1) and pointed in a SAFE DIRECTION
• Make sure the magazine is loaded and installed in the gun.
• Locate the cocking lever in the center of the airsoft gun and pull the lever back until it clicks. (Fig. 4)
• Release the lever.
• The airsoft gun is now cocked and ready to fire.
5. Aiming and Firing Safely
• You and others with you should always wear eye protection designed for airsoft to protect your eyes.
• Always point your airsoft gun in a SAFE DIRECTION.
• Do not shoot at hard surfaces or at the surface of water. The plastic BBs may bounce off or ricochet and hit someone or
something you had not intended to hit.
• DO NOT re-use plastic BBs because they could damage your airsoft gun.
• Your airsoft gun is designed for target shooting and is suited for both indoor and outdoor use. Always remember to place
your target carefully. THINK about what you will hit if you miss the target.
• When you are sure of your target and backstop, and the area around the target is clear, take the airsoft gun “OFF SAFE”
(section 2B), cock the airsoft gun (section 4), aim and pull the trigger to fire.
6. Maintaining Your Airsoft Gun
• DO NOT MODIFY OR ALTER YOUR AIRSOFT GUN. Tampering with the airsoft gun or attempts to change the airsoft gun in any way may
make it unsafe to use and voids the warranty.
• If you drop your airsoft gun, visually check to see that it works properly before you use it again. If anything seems changed, like a
shorter or weaker trigger pull, this may mean parts are worn out or broken. Call Customer Service at Crosman for assistance before
using your airsoft gun again.
A. To Clean the Barrel:
• Make sure the airsoft gun is “ON SAFE” (See Section 2.A) and pointed in a SAFE DIRECTION
• Remove the clip.
• Spray a cleaning patch with Crosman Nitro Lubricant oil.
• With patch on rod, insert in into barrel to clean
»Swab barrel 3-4 times
»Repeat swabbing procedure with a dry patch
• Barrel is clean when patches come out clean after dry swabbing.
B. Clearing a Jam
Never look down the end of barrel to see if a jam has been cleared.
• Make sure the airsoft gun is “ON SAFE” (See Section 2.A) and pointed in a SAFE DIRECTION
• Remove the clip from the airsoft gun.
• Insert the tapered end of the cleaning rod into the barrel, with the angle toward the breech (where the magazine connects).
• CAREFULLY and slowly apply more pressure until you push the BB out of the breech.
• Replace the clip and test gun.
7. Reviewing Safety
• Do not ever point the airsoft gun at any person. Do not ever point the airsoft gun at anything you do not intend to shoot.
• Always treat the airsoft gun as though it is loaded and with the same respect you would a firearm.
• Always aim in a SAFE DIRECTION. Always keep the muzzle of the Airsoft gun pointed in a SAFE DIRECTION.
• Always keep the airsoft gun “ON SAFE” until you are ready to shoot in a SAFE DIRECTION.
• Always check to see if the airsoft gun is “ON SAFE” and unloaded when getting it from another person or from storage.
• Always keep your finger off the trigger and out of the trigger guard until ready to shoot.
• You and others with you should always wear eye protection to protect your eyes.
• Always wear eye protection designed for airsoft over your regular glasses.
• Use 6 mm plastic BBs only.
• Do not reuse plastic BBs because they could cause damage your airsoft gun.
• Do not shoot at hard surfaces or at the surface of water. The plastic BBs may bounce off or ricochet and hit someone or something you had not
intended to hit.
• Replace the backstop if it becomes worn. Place the backstop in a location that is safe should the backstop fail.
• Your backstop should be checked for wear before and after each use. All backstops are subject to wear and will eventually fail. Replace your
backstop if the surface is worn or damaged or if a ricochet occurs.
• Do not attempt to disassemble or tamper with your airsoft gun.
• DO NOT MODIFY OR ALTER YOUR AIRSOFT GUN. Attempts to modify the airsoft gun in any way may make your airsoft gun unsafe to use, cause seri-
ous injury or death and voids the warranty.
• Using unauthorized repair centers or modifying the function of your airsoft gun in any way may be unsafe and voids your warranty.
• Do not put the airsoft gun away loaded. Make sure ALL of the plastic BBs are unloaded from the airsoft gun.
• Always store this airsoft gun in a secure location.
SPECIFICATIONS
Mechanism/Action Spring
Sights
Front: Blade
Rear: Peep Weight 2.75 lbs
Caliber/Ammunition 6 mm airsoft BBs Clip/Reservoir Up to 200 6mm airsoft BBs
Overall Length 34 inches Safety Lever in trigger guard
Magazine Up to 18 6mm airsoft BBs Velocity Up to 300 fps
PERFORMANCE: Many factors can affect velocity, including brand of projectile, type of projectile and barrel condition.
Your airsoft gun was designed to work with Crosman branded ammunition. Use of other ammunition may cause your gun to malfunction.
DO NOT RETURN THIS PRODUCT TO THE STORE.
Our friendly customer service representatives will be glad to help. You can get answers to frequently asked questions at www.crosman.com or you can contact us directly at
1-800-7AIRGUN (1-800-724-7486)
CUSTOMER SERVICE
If your airsoft gun is not functioning, we recommend that you call Crosman Corporation Customer service at 1-800-724-7486 or 585-657-6161. (International customers should contact
their distributor.) DO NOT ATTEMPT TO DISASSEMBLE IT! If you take it apart you probably will not be able to reassemble it correctly. Crosman assumes no warranty responsibility under
such circumstances.
For optimum performance use Crosman ammunition only. Using other than Crosman branded ammunition may cause your product to malfunction and may void your warranty.
LIMITED 30 DAY WARRANTY
This product is warranted to the retail consumer for 30 days from date of retail purchase against defects in material and workmanship and is transferable.
WHAT IS COVERED
Replacement parts and labor. Transportation charges to consumer for repaired product.
WHAT IS NOT COVERED
Transportation charges to Crosman for product. Damages caused by abuse, modification or failure to perform normal maintenance. Any other expense. CONSEQUENTIAL DAMAGES,
INCIDENTAL DAMAGES, OR INCIDENTAL EXPENSES, INCLUDING DAMAGE TO PROPERTY. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.
WARRANTY CLAIMS
USA Customers: Attach your name, address, description of problem, phone number and copy of sales receipt to product. Package and return to Crosman Corporation, Routes 5 & 20,
Bloomfield, NY 14469.
International Customers: Please return product to your nearest distributor. If you do not know your distributor, please call 585-657-6161 and ask for our International Department
for assistance.
IMPLIED WARRANTIES
ANY IMPLIED WARRANTIES, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO 30 DAYS FROM DATE OF
RETAIL PURCHASE. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATIONS MAY NOT APPLY TO YOU.
To the extent any provision of this warranty is prohibited by federal, state, or municipal law which cannot be preempted, it shall not be applicable. This warranty gives you specific legal
rights, and you may also have other rights which vary from state to state.
CROSMAN is a registered trademark of Crosman Corporation in the United States.
Fig 2A
“ON SAFE”
Fig 2B
“OFF SAFE”
Fig 3A
Fig 3B
Fig. 3C
Fig 4