Crosman SAPNSCA - Manual

!
!
!
!
Soft Air NightProwler
Soft Air Rifle
6mm plastic BB
OWNER’S MANUAL
READ ALL INSTRUCTIONS AND WARNINGS IN THIS MANUAL BEFORE USING THIS SOFT AIR GUN
P/N SAPNSC515
WARNING: Not a toy. Adult supervision required Misuse or careless use may cause serious injury, particularly to the
eye. May be dangerous up to 100 yards (91.44 meters).
WARNING: Do not brandish or display this soft air gun in public- it may confuse people and may be a crime. Police
and others may think it is a firearm. Do not change the coloration and markings to make it look more like a firearm.
That is dangerous and may be a crime.
Note: Charge the battery a MINIMUM of 4 hours and a MAXIMUM of 6 hours prior to initial use. This soft air gun will
not operate properly without a fully charged battery. DO NOT OVERCHARGE THE BATTERY.
YOU AND OTHERS WITH YOU SHOULD ALWAYS WEAR SHOOTING GLASSES TO PROTECT YOUR EYES.
READ ALL INSTRUCTIONS BEFORE USING.
BUYER AND USER HAVE THE DUTY TO OBEY ALL LAWS ABOUT THE USE AND OWNERSHIP OF THIS AIRGUN.
THIS AIRGUN IS INTENDED FOR USE BY THOSE 16 YEARS OF AGE OR OLDER.
Please read this owner’s manual completely. Remember, to treat this soft air gun with the same respect you would a
firearm. Always carefully follow the safety instructions found in this owner’s manual and keep this manual in a safe place
for future use.
If you have any questions, regarding your new soft air gun, please contact Crosman Customer Service at 1-800-724-
7486, 585-657-6161 or www.crosman.com.
1. Learning the Parts of Your New Soft Air Gun
Learning the names of the parts of your new soft air gun will help you to understand your owner’s manual. Use this
manual to increase your enjoyment of this soft air gun.
A Stock
B Butt
C Stock Release Tab
D Safety (see fig 2A and 2B)
E Mount
F Barrel
G Muzzle
H Loader
I Hop Up adjustment
J Mode Selector
2. Operating the Safety
WARNING: Keep the soft air gun in the “ON SAFE” position until you are actually ready to shoot. Then push the
safety to the “OFF SAFE” position.
2.1. To Put the Soft Air Gun “ON SAFE”:
• Locate the safety on the right side of the receiver. (Fig. 2A)
• Push the slide all the way forward to the “S” for “ON SAFE”. The gun is not “ON SAFE”
unless the slide is pushed all the way forward.
Like all mechanical devices, a soft air gun safety can fail. Even when the safety is “ON
SAFE”, you should continue to handle the soft air gun safely. NEVER point the soft air gun
at any person. NEVER point the soft air gun at anything you do not intend to shoot.
2.2 To Take the Soft Air Gun “OFF SAFE”:
• Locate the safety on the right side of the receiver. (Fig. 2B
• Push the slide all the way back to the “F” for “OFF SAFE
• The soft air gun is “OFF SAFE” and ready to fire the safety is all the way back toward the
“F” for fire.
3. Loading and Unloading Plastic BBs
3.1 Installing and filling the loading chamber
• Make sure the soft air gun is “ON SAFE.” (See Step 2.1)
• Point the soft air gun in a SAFE DIRECTION.
• To install the loading chamber.
o Loosen the mounting screws on the loading chamber
o With the small end toward the front of the gun, place loading chamber on the top rail,
be sure to line up the hole on the bottom of the loading chamber with the hole in the rail.
(Fig 3).
o Tighten the mounting screws.
• Once the Loading chamber has been installed slide open the loading chamber door on
the top of the clip.
• Fill the loading chamber with up to 600 BBs and slide the door closed.
WARNING: Use 6mm soft air BBs only in this soft air gun. Use of any other ammunition can cause injury to you or
damage to the soft air gun.
WARNING: Never assume that because the soft air gun no longer fires a BB and/or the loading chamber is
removed, that a BB is not lodged in the barrel. Always treat the soft air gun as though it is loaded and with the same
respect you would a firearm.
3.2 Unloading Plastic BBs
• Make sure the soft air gun is “ON SAFE.” (See Step 2.1)
• Point the soft air gun in a SAFE DIRECTION.
• Loosen the mounting screws and remove the loading chamber, being careful not to spill out the BBs.
• To empty the chamber, open the door on the top by sliding the door out and pour the BBs out into a container or your
hand.
• Point the soft air gun in a SAFE DIRECTION, take “OFF SAFE” and fire the gun in a safe direction until no more BBs
fire.
• Put the soft air gun back “ON SAFE”.
4. Charging the Battery
• Plug the white connector on the battery into the white connector on the battery charger.
• Plug the charger in to an outlet.
• Note: Charge the battery a MINIMUM of 4 hours and a MAXIMUM of 6 hours prior to initial use. This soft air gun will
not operate properly without a fully charged battery. DO NOT OVERCHARGE THE BATTERY
NOTE: The battery charging time is 4 hours. Continuous battery consumption will allow the gun to shoot for 15-
20 minutes. To prolong battery lifetime and maintain the best shooing performance do not shoot over 5 minutes
continuously in the Full Auto Mode.
5. Installing and Removing the Battery
5.1 Installing the Battery
• Make sure the soft air gun is “ON SAFE.” (See Step 2.1)
• Point the soft air gun in a SAFE DIRECTION.
• Make sure the loading chamber is installed on the gun.
• Remove the butt of the stock by pressing in the stock release tabs and pulling back on
the butt. (Fig. 4A)
• Locate the battery plug inside the stock.
• Plug the white connector on the battery clip in to the white connector attached to the
soft air gun. (Fig. 4B)
• Insert the battery into the stock so that the end with the wire connector is facing out.
• Tuck the connectors inside the stock.
• Replace the butt, pushing in until it locks in place.
• The soft air gun is now charged.
Crosman Corporation • 7629 Rts. 5 & 20 • East Bloomfield, NY 14443
www.crosman.com • 800-7Airgun (724-7486)
5.2. Removing the Battery
• Make sure the soft air gun is “ON SAFE.” (See Step 2.1)
• Point the soft air gun in a SAFE DIRECTION.
• Remove the butt of the stock by pressing in the stock release tabs and pulling back on the butt.
• Unplug the battery clip and remove from gun.
6. Selecting the Firing Mode
Your soft air gun is designed to fire in semi-auto or full auto mode. Full-auto
means it will continue to fire plastic BBs as long as you HOLD the trigger. Semi-
auto means you will have to pull the trigger each time you want to fire a shot.
• To select the mode locate the mode selection lever on the left side of the soft
air gun. (Fig. 5)
• Turn the dial to the desired mode of fire. Be sure to completely turn to the
desired position.
7. Selecting the Hop-Up Mode
Your soft air gun is designed with a hop-up system. The purpose of this system
is to change the spin on the BB as it leaves the muzzle allowing you to adapt your
shot for different distances. There are two possible adjustments.
• Locate the hop-up slide on the left side of your gun, under the loading
chamber.
• Push the slide located on the left all the way back for more spin.
• Push the slide all the way forward for less spin.
8. Aiming and Firing Safely
NOTE: This soft air gun fires in semi-auto or full-auto mode see section 6.
• You and others with you should always wear shooting glasses or goggles designed for soft air use to protect your
eyes.
• Always point your soft air gun in a SAFE DIRECTION.
• Do not shoot at hard surfaces or at the surface of water. The plastic BBs may bounce off or ricochet and hit someone
or something you had not intended to hit. If the plastic BBs should happen to hit a hard surface, DO NOT re-use
those plastic BBs because they could possibly cause damage to your soft air gun.
• Your soft air gun is designed for target shooting and is suited for both indoor and outdoor use. Always remember to
place your target carefully. THINK about what you will hit if you miss the target.
• When you are sure of your target and backstop, and the area around the target is clear, take the soft air gun “OFF
SAFE” (See Section 2.2) and pull the trigger to fire.
9. Maintaining Your Soft Air Gun
• DO NOT MODIFY OR ALTER YOUR SOFT AIR GUN. Tampering with the soft air gun or attempts to change the soft
air gun in any way may make it unsafe to use and will void the warranty.
• If you drop your soft air gun, visually check to see that it works properly before you use it again. If anything seems
changed, like a shorter or weaker trigger pull, this may mean parts are worn out or broken. Call Customer Service at
Crosman for assistance before using your soft air gun again
10. Reviewing Safety
• Do not ever point the soft air gun at any person. Do not ever point the soft air gun at anything you do not intend to
shoot.
• Always treat the soft air gun as though it is loaded and with the same respect you would a firearm.
• Always aim in a SAFE DIRECTION. Always keep the muzzle of the soft air gun pointed in a SAFE DIRECTION.
• Always keep the soft air gun “ON SAFE” until you are ready to shoot in a SAFE DIRECTION.
• Always check to see if the soft air gun is “ON SAFE” and unloaded when getting it from another person or from
storage.
• Always keep your finger off the trigger and out of the trigger guard until ready to shoot.
• You and others with you should always wear shooting glasses or goggles designed for soft air use to protect your
eyes.
• If your reading or prescription glasses are not safety glasses make sure you wear shooting glasses or goggles over
your regular glasses.
• Use 6 mm plastic BBs only.
• Do not shoot at hard surfaces or at the surface of water. The plastic BBs may bounce off or ricochet and hit someone
or something you had not intended to hit. If the plastic BBs should happen to hit a hard surface, do not reuse those
plastic BBs because they could cause possible damage to your soft air gun.
• Replace the backstop if it becomes worn. Place the backstop in a location that will be safe should the backstop fail.
• Do not attempt to disassemble or tamper with your soft air gun. Modifying the function of your airgun in any way may
be unsafe and will void your warranty.
• Do not put the soft air gun away loaded or with a charged battery. Make sure ALL of the plastic BBs are unloaded
from the soft air gun and the battery is removed.
• Always store this soft air gun in a secure location.
SPECIFICATIONS
Mechanism/Action Electronic
Caliber/Ammunition 6mm plastic BBs
Reservoir Up to
600 BBs
Weight 4.08 lbs
Overall Length 32 inches
Safety Slide
Velocity up to 325 fps
PERFORMANCE
Many factors can affect velocity, including brand of projectile, type of projectile and barrel condition..
CUSTOMER SERVICE
If your soft air gun is not functioning, we recommend that you call Crosman Corporation Customer service at 1-
800-724-7486 or 585-657-6161. (International customers should contact their distributor.) DO NOT ATTEMPT TO
DISASSEMBLE IT! If you take it apart you probably will not be able to reassemble it correctly. Crosman assumes no
warranty responsibility under such circumstances.
LIMITED 30 DAY YEAR WARRANTY
This product is warranted to the retail consumer for 30 days from date of retail purchase against defects in material and
workmanship and is transferable.
WHAT IS COVERED
Replacement parts and labor. Transportation charges to consumer for repaired product.
WHAT IS NOT COVERED
Transportation charges to Crosman for product. Damages caused by abuse, modification or failure to perform normal
maintenance. Any other expense. CONSEQUENTIAL DAMAGES, INCIDENTAL DAMAGES, OR INCIDENTAL
EXPENSES, INCLUDING DAMAGE TO PROPERTY. SOME STATES DO NOT ALLOW THE EXCLUSION OR
LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY
NOT APPLY TO YOU.
WARRANTY CLAIMS
U.S. Customers - Attach your name, address, description of problem, phone number and copy of sales receipt to
product. Package and return to Crosman Corporation, Routes 5 & 20, East Bloomfield, NY 14443.
Canadian Customers - Follow packaging procedures above and send to Crosman Parts & Service Depot, 611 Neal
Drive, Peterborough, Ontario, K9J 6X7 Canada.
International Customers - Please return product to your nearest distributor. If you do not know your distributor, please
call 585-657-6161 and ask for our International Department for assistance.
IMPLIED WARRANTIES
ANY IMPLIED WARRANTIES, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO 30 DAYS FROM DATE OF RETAIL PURCHASE.
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE
LIMITATIONS MAY NOT APPLY TO YOU.
To the extent any provision of this warranty is prohibited by federal, state or municipal law, which cannot be preempted,
iTo the extent any provision of this warranty is prohibited by federal, state, or municipal law which cannot be preempted,
it shall not be applicable. This warranty gives you specific legal rights, and you may also have other rights which vary
from state to state.
CROSMAN is a registered trademark of Crosman Corporation in the United States
G
A B
C
D
E
F
H
I
J
Fig. 2A
Fig. 2B
Fig. 3
Fig. 4A
Fig. 4B
Fig. 5
Fig. 6