Drawmer DA6 Balanced Distribution Amplifier - Manual (Page 3)

DA6 OPERATORS’ MANUAL 
DRAWMER DA6
Distribution Amp
SAFETY CONSIDERATIONS
CAUTION - MAINS FUSE
TO REDUCE THE RISK OF FIRE REPLACE THE MAINS FUSE ONLY WITH
THE SAME TYPE, WHICH MUST BE A CLASS 3, 230 VOLT, TIME DELAY
TYPE, RATED AT 160mA WHERE THE MAINS INPUT VOLTAGE SWITCH IS
SET TO 230 VOLTS AC. AND 315mA WHERE THE MAINS INPUT VOLTAGE
IS 115 VOLTS AC.
ALL FUSES MUST COMPLY WITH IEC 127-2.
THE FUSE BODY SIZE IS 20mm x 5mm.
CAUTION - MAINS CABLE
DO NOT ATTEMPT TO CHANGE OR TAMPER WITH THE SUPPLIED MAINS
CABLE.
CAUTION - SERVICING
DO NOT PERFORM ANY SERVICING. REFER ALL SERVICING TO
QUALIFIED SERVICE PERSONNEL.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE.
CAUTION - HEADPHONES
THE HEADPHONE AMPLIFIER IN THIS UNIT IS CAPABLE OF PRODUCING
1 WATT INTO 8


SPEAKERS. DRAWMER DO NOT ACCEPT ANY
RESPONSIBILITY FOR DAMAGE CAUSED TO OPERATOR HEARING OR
SPEAKER DEVICES BY USE OF EXCESSIVE OUTPUT LEVELS.